Plastic Restoration and New Stickers to FINISH the Moto 4 200!!
HTML-код
- Опубликовано: 27 авг 2024
- The Moto 4 is DONE!!! Yay! lol The epic saga comes to an end. Man, what a difference it is compared to how it started!
Plastic's Graphics - www.replacemen...
Label Stickers - www.bluelinede...
Seat Cover - www.ebay.com/i...
If you like what we're doing here at Toy Shop and would like to support us then be sure to check us out on Patreon! www.patreon.co...
Pryme offers a ton of easy products to make your machine look better than factory. They offer a huge assortments of buffing and sanding wheels for aluminum and plastic and they work amazing at bringing an old machine back to new. To check them out click here - www.prymemx.co...
Using these links below will help me out!
Toolbox Widgets
1/4" drive Socket Widget - a.co/d/29Ux2rs
3/8" drive Socket Widget - a.co/d/5cCi3mT
1/2" drive Socket Widget - a.co/d/8EsPl9s
Screwdriver Widget - a.co/d/5F7EB5Y
Wrench Widget - a.co/d/0qyVzIM
Wide Motorcycle Scissor Jack - a.co/d/fQLQypt
Narrow Motorcycle Scissor Jack - a.co/d/cGDv73u
Umbilical tank setup;
Moton Pro Aux Tank - a.co/d/2hMd2xe
IV Stand - a.co/d/hHiSSGU
Metric #2 Phillips - a.co/d/1qhV0me
Slide Hammer - a.co/d/e8bu3yW
Camera I use to film - a.co/d/9d39Jjm
Mic I use - a.co/d/0V4vNZ7
Visit us at www.toyshop966... to see what we're up to and to check out everything Amsoil has to offer!
That old bike brings back some memories. We have one on the farm. It was very reliable and would go through just about anything without getting stuck It would pull a loaded hay wagon as long as you could get traction That super low would pull. We still have it but it's sitting outside in the graveyard probably seized at this point. It had a rough life. It definitelyowed us nothing.
great job!
Hey good job!
Where did you find that seat cover.
Also a good way to patch up the seat foam is with carpet foam. 👍
Great tip! I just added the link to the description for you!
What did u do to remove the old spray paint thanks!
I only did what I showed in the video. I used the citrus stuff to get the bulk of it off and then I sanded it to get the rest off.
Did you rebuild the shifter
Like the part you touch to your toe? I took the rubber piece off and re zinc plated in and put a new rubber piece on it.
In the inside cuz mine dose want to go in gear ⚙️
Could you give the sizes of the stickers I would like to remake them myself?
Your best bet would probably just be to look at where mine are and roughly measure out how big that area is on your plastic! Hope you get it!
Ok will do that thanks