How to convert server power supply to power car amplifier rc lipo charge HP DPS 600PB
HTML-код
- Опубликовано: 16 мар 2016
- this is how I converted a HP DPS 600PB server power supply to work with my amp. works great and its QUIET. here is a link to the pin outs
sites.google.com/site/tjinguy... Авто/Мото
Hello,
I need two 12v outputs, can I use the 1st and 3rd hot-swap for one out put and the 2nd and 4th for another?
How much amperage will I get from each rail? Will it be the same for both or will one be more then the other?
Kind regards, Chi
Does anyone have the pinout of the DELTA DPS-1000DB A power supply? I can´t find anything in the web.
Thanks.
Awesome video do you have anything to such as a pot to vari the current thanks again
How did you figure out those pins which is which? I need help with Dell poweredge M1000E
i googled the model number and got a pin out diagram for mine. some of these server power supplies have not been tested yet and will not have a mod or hack for it. better off finding one that somebody already did all the hard work to find which pins to jump and buy that one.
Hi Doing good. i need your help. how to switching server power supply model #AP15FS44 and and HP Model # DPS-700CB A
I have 2 of them, but only 6.5 A
how to switching ACBELModel number API5FS44 . pls help
I got HP switching power supply DPS -1200FB A
I want connector pinout diagram can you help me?
I have two power supply, power-one,model are spasunm-07. And spacsco-26g, i dont know how to start them,please help me if you know, thank you verymuch,bro
12 to 13-8v plz calear
1
少康戰情室
/少康戰情室
FYI: I figured out how to turn on 800W DPS-800AB-1 A, info here: www.rcgroups.com/forums/showthread.php?3292601-HP-Server-Power-Supply-800W-DPS-800AB-1-A-How-to-Turn-On&perpage=100#post41700387
Hi I got a simular problem as below but with a 1500W Fuji Electric CA05958-1020. Can't find any pin diagrams. Any assistance please? Here's a link to the uploaded image.
Many thanks
i66.tinypic.com/352q81c.jpg
since there is no pin out diagrams or tuts on how to turn it on then the only thing you can do is take a small piece of wire and start shorting out the small pins. to see which two turn it on. the big ones are your output.
bam6972 Thank you. Will it be just two pins to short out together not across 3 or anything like that?
it should be just 2 pins i do believe. there usually close together.
bam6972 Excellent. I'll give it a go later today if I get time and let you know.
bam6972 Managed to get it powered on so that's a good start and thanks for the tip. However it's a 1500w power supply but it cuts out when it uses over 850w. Works fine up to 850w but the second it goes over it knocks out. Using it to charge my ebike and I can increase the amperage for the charge. Didn't like going over 15A though. It's meant to be a 48v 30A output. Maybe you can give some insight? Cheers