This will be needed in every workshop. Woodworking. DIY.
HTML-код
- Опубликовано: 20 сен 2024
- In this video, I will show how to make a carriage for a router to level slabs or tables made of epoxy resin.
SUBSCRIBE:
WOODEN DESIGN
/ @wooddesign6730
WD Restoration
/ @wdrestoration
#woodworking #diy #Woodworking Projects
تمام مدت منتظر یک ابتکار جدید بودم ولی نشد که بشه !!!
Just a DIY planer that's not all that sturdy, and with a more complex build out than was needed (use strips instead of cutting out the middle).
Hola EASY MAKE , muy buen proyecto felicidades y gracias por tú valioso tiempo.
Keren hasilnya 🎉
Super banaya bhay
Great job
Thank you so much for watching.
One question why did you have to drill twice before fixing with screws, the first was a countersink but then you used a second drill bit?
screws were longer than the countersink might not be absolutely necessary but not a bad habit in the edge grain of plywood
Very good but your dust extractor isn't being used enough you may have a mask but the dust will go everywhere in your workshop and be moved about all over just an observation I suffer with a bad chest so it is so noticeable
Ok- I’m not sure what high school this was filmed at- but I have no idea what he made or used the box for. At the 7 minute mark I was ready to install a ballast and wiring
It's a router sled, with a flattening bit it's used to do just that - flatten pieces of wood. Typically end grain or large slabs to big for a thickness planer
Llllllll
L
L
L
👋👍
👍💪🤝
Safety tip. Never let go of a spinning router.
В мастерской имеется рейсмус , а с этой лабудой топорная работа получается.
Мне не понадобится!
Годно!👍👏
Дякую за перегляд.
@@easymake414 дякую за вiдio
Без того пристрою,що циклює наврятче!
It won't be needed in my workshop. If I need to thickness an area I would use my CNC router.
+
Please title your videos!
Waste of materials and time rails too high and need better guides on bottom. Poor technique used.
What a complete joke and a waste of time and lumber…