Размер видео: 1280 X 720853 X 480640 X 360
Показать панель управления
Автовоспроизведение
Автоповтор
This is a great video!! Super easy to understand the process
@Manny-b163 Thanks!
Easy peasy
@ivanpeterzell695 Easy Peasy Brother!
Why not use an Indexing Pry Bar to take out the injector? It's so much easier since you use leverage, you can do it with one hand.
@a_6foot_midget739 I tried it but I couldn't do it with a pry bar!
The inyector it doesn’t need a cooper washer at the bottom?
@ferbustos8165 No!!
I do have one question. The injectors are supposed to shoot out a bit of liquid correct?
@Manny-b163 Yes!
You don’t have to set the trim files or whatever on the computer for these injectors
@JDA77 Yes! you have to set the trim files in the PCM afterwards!
How do you know the seals or oring is bad?
@fastwayimpo they leak out oil from the injector base!
This can cause a blow by?
This is a great video!! Super easy to understand the process
@Manny-b163 Thanks!
Easy peasy
@ivanpeterzell695 Easy Peasy Brother!
Why not use an Indexing Pry Bar to take out the injector? It's so much easier since you use leverage, you can do it with one hand.
@a_6foot_midget739 I tried it but I couldn't do it with a pry bar!
The inyector it doesn’t need a cooper washer at the bottom?
@ferbustos8165 No!!
I do have one question. The injectors are supposed to shoot out a bit of liquid correct?
@Manny-b163 Yes!
You don’t have to set the trim files or whatever on the computer for these injectors
@JDA77 Yes! you have to set the trim files in the PCM afterwards!
How do you know the seals or oring is bad?
@fastwayimpo they leak out oil from the injector base!
This can cause a blow by?