Ano po ba dahilan bakit d magbomba ng oil ang 2e engine ko Bago na oil pump nalinis na oil pan at sa screen sa ilalaim Oil changed na bakit walng pumapasok na langis sa oil filter at sa cam Salamat po
hey mate check to make sure that the oil pump is still in good working condition. And i would also check the oil pickup and make sure nothing is blocking it and that the o ring is intact also check the oil relief valve. it sound like a oil pressure issue because you are not getting oil to the head or the filter it
@@RuggedGarage though would it vary with the ambient temp of our locations? i live on a tropical country. also, recently after i took it to a local touge, it has no power when i put on the throttle more than 30% and also on 4k+ rpm could it be a dirty fuel issue?
stock oil pressure at idle is 3.5kg(49psi) and at high rpms it goes to 5kg(71psi) using 20w-50w oil if you put 1 washer in it will increase to around 6kg(85psi)
Amazing..so simple..and i Will do this
algood mate
2E ❤
Thank you so much, so if I put 2 is that enought for my seup with DCOE carbs?
Yep should be around 70psi at full rpms
Whats the best oil then for high rpm for long times as I dokt want to do any harm to my engine?
i always use 20w-50w Castrol
If I have upgraded valve springs with a stock intake on a 2e efi motor, how many washers would you recommend?
2 washers would be good
Hi there! bro, do you know if a C52 gearbox is compatible with 2E engine? Greetings from Guatemala
yes it is but u will have to change to bell housing on the gearbox
@@RuggedGarage thanks a lot bro
I have low oil light on idel rpm when i increas rpm light goes off , can i use this method ?
Change the pump before it cost you a engine
Might be bad oil pump or too much wear on clearances.
is 3 washer to much for a N/A 2e motor?
2-3 washer is good for a na motor depends on if it high performance or not if not go for 2 washers
My plan is to make my 2e have twin carbs, cuz I got some carbs from an old Celica
@@alexhs0595 that's sick yea go with 2 1mm washers that will be perfect mate
Ano po ba dahilan bakit d magbomba ng oil ang 2e engine ko
Bago na oil pump nalinis na oil pan at sa screen sa ilalaim
Oil changed na bakit walng pumapasok na langis sa oil filter at sa cam
Salamat po
hey mate check to make sure that the oil pump is still in good working condition. And i would also check the oil pickup and make sure nothing is blocking it and that the o ring is intact also check the oil relief valve. it sound like a oil pressure issue because you are not getting oil to the head or the filter it
estimating i put 2 washers with motul 10w-40, should go for 80-90psi right?
Yea it will be around that pressure but I would recommend 20w-50w Ive used 10-40 but it goes very thin fast
@@RuggedGarage though would it vary with the ambient temp of our locations? i live on a tropical country. also, recently after i took it to a local touge, it has no power when i put on the throttle more than 30% and also on 4k+ rpm could it be a dirty fuel issue?
@@FuraiFuru you will probably find that that is either a carb issue or a spark issue
If I only put 1 washer how much oil pressure in psi would it be?
stock oil pressure at idle is 3.5kg(49psi) and at high rpms it goes to 5kg(71psi) using 20w-50w oil if you put 1 washer in it will increase to around 6kg(85psi)