Thanks just the video I needed. Just bought an 05 that runs good but could be better si I'll be looking through your repair videos to help me. Thanks I'm subscribed
I found big vaccum leaks where throttle shafts work. Did anyone disasembled throttle? Can't find any information on the web about rebuilding this part of carbs
Good info, but a little hard to see some parts, but that goes with the job. Is it right the valves shims, need to be checked every 4K miles ? Was thinking of buying one, they sell real cheap, and seem to be a good bike, just not very powerful, but that is ok, it's for other family members to ride with me, and I want to be faster then them. lol ------Thanks, yl
I have a 2004 GS500F. Today it just started to stall when I put it in Choke. If I leave it OFF choke it is fine and runs great. When I switch it to Choke it stalls out and won't start. Normally it will start and run great and climb to 4000 RPM and then I back it off choke and it will idle perfectly. Any suggestions on what happened? Thanks!
Quick question do you have to remove the choke from the carb to access the vaccine nipple I can't seem to get my gauge onto it with it there is am I missing something?
I had the same issue on my 2005 if you are using the factory frame mounted petcock and have all of your vacuum hoses hooked up correctly then you may need to dissasemble your petcock and clean the internals. My issue was the vacuum hose that is connected to the rear of the petcock that opens and closes a valve in the petcock that allow gas to only flow when the engine is running anyway the valve was sticking and allowing gas to continue to flow into the carb until it would leak from the air box.
CAN SOMEONE GIVE THEIR ADVICE??? I just got my first bike a 2006 GS500 and i was wondering if you could give some suggestions as to what can do to keep it in tip top condition. i was thinking of doing a carb sync. Its only done 10k and has just had a service. any advice would be good, i noticed the forks are a bit soft is their a way to change that? thanks
hello everyone I just got a 2004 GS 500f 5 days ago most IV done with it is take it to 100 no stunt or anything and now my air filter was full of gas when I got home what could be doing this please anyone help me with this problem
What a waste of a video. Nobody knows what he's doing. What screw did he turn? How many turns? Which direction? Next video. Perhaps put a little more detail into what all you are doing. Because honestly, you showed EVERYTHING, how to disassemble most of the fuel system and lines. But how do you adjust the carbs?
One of the best GS500 videos out there!
GS twins whip doing God's work out there buddy
Awesome! I love working on my GS500F
Im in the maryland area and would like to get my bike worked on by you.
Do you have a shop or any way i can get in touch with you .
Thanks
Thank you sir
Are you still in the Baltimore Area?
Thanks just the video I needed.
Just bought an 05 that runs good but could be better si I'll be looking through your repair videos to help me.
Thanks I'm subscribed
Hi Great video.. can I ask why you needed to take of the side fairings? I cant see the need to take them off or am I missing something?
Thanks
What's the name of the part under the carbs thats attached to engine
Accesing the left carb nipple is a real pain in da ass
I found big vaccum leaks where throttle shafts work. Did anyone disasembled throttle? Can't find any information on the web about rebuilding this part of carbs
Good info, but a little hard to see some parts, but that goes with the job. Is it right the valves shims, need to be checked every 4K miles ?
Was thinking of buying one, they sell real cheap, and seem to be a good bike, just not very powerful, but that is ok, it's for other family members to ride with me, and I want to be faster then them. lol ------Thanks, yl
I have a 2004 GS500F. Today it just started to stall when I put it in Choke. If I leave it OFF choke it is fine and runs great. When I switch it to Choke it stalls out and won't start. Normally it will start and run great and climb to 4000 RPM and then I back it off choke and it will idle perfectly. Any suggestions on what happened? Thanks!
Do you have a dynojet?which one? Whats your carb code ?ı have a 2003 gs500? Your carb code and mine are same?
Quick question do you have to remove the choke from the carb to access the vaccine nipple I can't seem to get my gauge onto it with it there is am I missing something?
Will my 06 gs 500f run if I just plug all the vacuum hoses on the carbs? Because I can't seem to route them correctly without buying a manual.
quick question if my carbs are not sync could it cause it to flood my airbox
Bino Martinez did you ever find out if that the reason y your GS 500f airbox floods cuz I'm having the same problem
Joey Davis dont have the bike anymore but the guy i sold it to got the carbs rebuilt and that fixed the problem
I had the same issue on my 2005 if you are using the factory frame mounted petcock and have all of your vacuum hoses hooked up correctly then you may need to dissasemble your petcock and clean the internals. My issue was the vacuum hose that is connected to the rear of the petcock that opens and closes a valve in the petcock that allow gas to only flow when the engine is running anyway the valve was sticking and allowing gas to continue to flow into the carb until it would leak from the air box.
Hi, I was wondering what is the RPM standard at idling speed, is on a 2004 gs500F?
1300-1400 Rpm for the idle.
CAN SOMEONE GIVE THEIR ADVICE??? I just got my first bike a 2006 GS500 and i was wondering if you could give some suggestions as to what can do to keep it in tip top condition. i was thinking of doing a carb sync. Its only done 10k and has just had a service. any advice would be good, i noticed the forks are a bit soft is their a way to change that? thanks
gglafatottari Drullusukkor the forks wont feel so soft if you lose some weight fatty
@@heemlo649 bro what? Why tf u so rude man chill out.
Very nice! ... although maybe its better to check for leaks, BEFORE you put the seat and fairings back on.. :p
:)
what is yours carbs code ?whats yours jetkit ?
hey guys i need your help
hello everyone I just got a 2004 GS 500f 5 days ago most IV done with it is take it to 100 no stunt or anything and now my air filter was full of gas when I got home what could be doing this please anyone help me with this problem
What a waste of a video. Nobody knows what he's doing. What screw did he turn? How many turns? Which direction? Next video. Perhaps put a little more detail into what all you are doing. Because honestly, you showed EVERYTHING, how to disassemble most of the fuel system and lines. But how do you adjust the carbs?