2013-2014 Ford Focus ST Performance Air Intake Installation Guide by Mishimoto

2013-2014 Ford Focus ST Performance Air Intake
www.mishimoto.com/ford-focus-s...
Engineering: engineering.mishimoto.com/?cat...
Facebook- mishimoto.com/facebook-redirec...
Twitter- www.mishimoto.com/twitter-redi...
Instagram- mishimoto.com/instagram-redire...
Model: MMAI-FOST-13
•Direct fit for 2013+ Ford Focus ST
•Dyno-proven maximum gains of up to 6 whp and 5 wtq on the stock tune
•Highly aggressive intake tone under acceleration
•Designed to work with stock tune with no additional tuning required
•Black powder-coated airbox keeps unwanted hot air from entering the air filter
•Air filter placed to receive maximum airflow from the front of the vehicle
•Available with a polished or wrinkle black pipe
•CARB Compliant EO#: D-759-1
•Mishimoto Lifetime Warranty
Disclaimer
• Please dispose of any liquids properly.
• Allow vehicle to cool completely prior to attempting installation.
• Mishimoto Performance (MP) is not responsible for any vehicle
damage or personal injury due to installation errors, misuse,
or removal of MP products.
• MP always suggests that a trained professional install all
MP products.
• Do not run the engine or drive the vehicle while overheating.
Serious damage may occur.
• Raise vehicle only on jack stands or on a vehicle lift.

[@cNicholasAllen]

Would this for on a SE model or is it only for ST

[@MikeBeazy]

this is a very pricey unit, but it is clear the production quality is in the box portion of the cold air intake. I have a $150 ebay cold air intake that ends in a pod filter in the engine bay with no "airbox" around it. Im curious to see a performance difference..

[@cartergilster8575]

I had a couple of clamps left over and a hose, I hope I did it right

[@mishimoto]

It sounds like you had the parts meant for the 2016+ model left over. If you car is older than 2016 there is nothing to worry about you wont have any need for these parts.

[@chriswarner8696]

What are you supposed to do about the crank case sensor on the hose?

[@mishimoto]

For vehicles equipped with this sensor a hose is included to size down to the sensor to allow for this to be installed.

[@sur3tv]

if i were to take the top of the airbox off does it seal fully when i close the hood to block out hot air?

[@mishimoto]

The cars hood would not provide a seal for the airbox to prevent hot air from entering

[@sur3tv]

the mounting peg on the left for the air box is attached to nothing? does it connect to the stock air box ?

[@mishimoto]

If you are refering to the one that is removed and installed on our airbox this goes into a locating mount on the car.

[@sur3tv]

is the intake pipe suppose to get super hot even after the car been off for 2 hours pipe still hot

[@mishimoto]

Please feel free to reach out to our support team at [e-mail], they would be happy to review this with you.

[@gemmahaskell1295]

Alrite ahac, I’ve just got 1 of these and my intake pipe is the same, did u find out if this is supposed to happen, cheers

[@terr256]

Will this fit the 2018 focus st?

[@mishimoto]

This will fit the 2018 model Focus ST

[@sur3tv]

would a mishimoto intake for an rs fit on a 2014 st?

[@mishimoto]

We would not recommend installing our RS intake onto a ST