Full-Race Honda 9th Gen Civic Si 3" All-Motor Downpipe Install
HTML-код
- Опубликовано: 7 сен 2024
- The Full-Race Honda 9th Gen Civic Si 3" All-Motor Downpipe is available now! Designed to extract maximum power from naturally aspirated K24Z7 engines, our high flowing design delivers significant power and torque gains throughout the power band by reducing back pressure and increasing flow. Looking for the ultimate exhaust combination? Pair our the Full-Race All Motor Downpipe with the Full-Race 9th Gen Civic Si 3" Exhaust System for additional horsepower, torque and superior tune.
For more information visit us at www.full-race.com
Good to see these guys doing well. They helped me years ago with my setup. Geoff and his staff are great people.
Full race vs skunk2
I don't see why people complain about the head, it works great if you are going turbo and this 3" downpipes are proven to make the k24z7 gain over 13 whp. If you like the 8th gen better than this 9th then keep the 8th gen don't hate.
so you need to take the windshield wipers off? Are there any step by steps for this install? Just got mine today and am more comfortable following a diy guide.
Did you guys use the stock gasket between the dp and the manifold?
sounds friggin awesome!
is that with just the FR downpipe??
with the catted downpipe ... will it pass smog ??? I know it will most likely not pass visual but will it pass the sniffer...
Installing this down pipe would give my car a check engine light?
wow honda finally moved the oil filter? shit man i remember when it was a mission to change the oil
which downpipe its better
Was this fly by with DP only, everything else stock?
are you guys going to put up any vids of the 9th gen turbo setup you guys have out?
Anyone else hear the whistle noise? Have a friend with an 8th gen and his car whistles and he's all stock can't seem to figure out the problem.
Does anyone know what that piece is called that they are taking off @1:55
Can't get the damn o2 sensor off the bottom. Got the downpipe out and everything. Iv soaked it for hours in liquid wrench. Hit it with hammers. Iv tried everything. Guess I'll just get a new sensor
Have you used an O2 socket wrench? You can rent them at autozone
+TheNuke95 Yeah the socket didn't work. Ended up stripped the outside. Soaked it in liquid wrench for 20 hours then took a big ass pipe wrench to it and it finally came off.
is anyone else having clearance issues particularly where the last two bends are right before the silencer
Michael Burns does this downpipe hit any part of your vehicle while driving?
Hey guys so i put a full race no cat downpipe but my car is studdering (its choking ) can u guys give me any advice or ideas what it could nake it do this? I have no check engine light
Andy Mendez What was causing the problem?
It was one of the defoulers on the O2 sensor number 2
Andy Mendez get it tuned by Vit
What size socket did u used to remove the top 02 sensor? I just purchased this down pipe from you guys and i need to go buy the socket before i take everything apart thanks in advance
Does anybody else have a problem with it tapping the subframe?
yeah gonna heat wrap mine it runs tight right before the silencer
Any dyno information?
what headers would you recommend for your full setup of the downpipe and exhaust?
This is a K20z7, the down pipe is the header, it’s called an integrated exhaust
For the downstream O2 Sensor (bottom sensor), did you unplug the o2 cables in order to get it in the downpipe?
I'm having trouble with this part of the install cause the electrical wiring is long enough to reach the downpipe