My mannnn!!! After watching 5 videos and struggling for an hour on the side of the road, this finally worked. God damn that tire was a bitch to take off.
I had to go to step two. I only had to move the car a few feet and the rim released from the lugs ( I could hear it. I like you demonstrated, back the lug nut slightly away from the rim about a 1/4- 1/3 turn. Thanks Mucho! PS In the video, when you released the jack it sort of dropped, thus it gave enough jerk to snap the lugs free. Whereas, I had the jack that came with my Honda (V Jack).
Just had to listen to two we're super mechanics blah blah never seen a wheel like this etc. 3 min later after watching your video, hey guys try this. Ahhhh the look of blank faces, its the little things in life😁. Thanks for the tip 👍
You're right does not work for flat Tyre.. what l had to do was slack the lugs.take out jack..start the engine.drive a couple second turn right and left, then you'll hear a snap.. it's free.. just letting you know..!!
I usually jacked up the car put a piece of wood or flat rock on the inside bottom of the tire and lower it down with the lug nuts LOOSE so the weight of the car will pop it out . It works most of the time but right now it didn't so I'll give this a try Thanks 👍
Glad it helped. Please like and subscribe as it helps my channel support charity and yes you can support it too by donating to PayPal id: Dewana421@aol.com. No amount is small :)
When I got Flat on the highway, my tire was STUCK STUCK. Literally everything tried failed, I even put it back down, no lug nuts on tire and drove forward and backward & tht wouldn’t even work. A cop stopped and said he’s never seen a tire so stuck before, I resorted to using a hammer & after few hits it finally came off. WHY do tires stick like that??!
Because they should have antiseeze between them and rotors but someone didn’t put it and if you don’t rotate your tires for a while then it stays there long and fuse together due to corrosion and moisture.
I got a flat on my Audi a4 2007 back tire and its stuck like this, do i need a tool to removed the center piece or do i the exact same thing you did in this video? Im super confused!
I want to make sure I understand what you did. You jacked up your car, took off all the lug nuts, then loosely hand tightend 2 lug nuts, then you jacked down the car, then the wheel came off. Did I get everything right?
Yes correct. In some cases it still doesn’t come out like then the best way is to loosen your all 4 lug nuts (not all the way loose but like 2 hand turns so it’s loose but still holding wheel - after you loosen it by wrench). Then jack it down and then drive a little and the wheel will come loose. Just make sure it’s not so loose that the wheel comes off or gets wobbly. It should just be enough to loosen it off but keep the wheel in place.
Thanks for posting this. I was unsure how to proceed. I had to raise and lower it a couple times and then a couple kicks, but it popped loose. Thanks again.
Just spent 20 minutes trying this, my dad comes along, sprays WD-40 into lug nut holes, jacks up the car and uses a rubber hammer to hit the back side of the wheel outward, literally one hit
What I can recommend is jack up your vehicle after loosening up all the bolts and make sure you lose it enough, but don’t take them off and then put the jack down suddenly and that will loosen up your rim. If you cannot take it down suddenly, then slowly would work too.
Reporting back. It work for me. I actually had to do the second option mentioned, just forward and backward in the driveway. I'm an anti-seeze believer now.
fuck bmw my x5 front wheel does want to come out no matter what i do even i drove it without bolts for 10 miles and still wont come out. fuck this shit
@@thomasmaher6880 I did but I always keep a repair kit in my car and it takes me 5mins to repair a flat…and I don’t take my wheel off to repair a flat. Those plug-in kit works wonders.
Thank you so much. Just tried on my stuck tire and worked perfectly!!!
Glad it helped. Please like and subscribe as it helps my channel supporting charity :)
My mannnn!!! After watching 5 videos and struggling for an hour on the side of the road, this finally worked. God damn that tire was a bitch to take off.
I had to go to step two. I only had to move the car a few feet and the rim released from the lugs ( I could hear it. I like you demonstrated, back the lug nut slightly away from the rim about a 1/4- 1/3 turn. Thanks Mucho!
PS In the video, when you released the jack it sort of dropped, thus it gave enough jerk to snap the lugs free. Whereas, I had the jack that came with my Honda (V Jack).
My mom has a flat and im out of town. Sending her this bro thank you🤙
THANK YOU!!! it worked perfectly!!! when i was jacking the car back up the wheel fell off!!! Thanks so much!!!
Glad it helped. Please like and subscribe as it helps my channel supporting charity :)
Thank u very much. Worked perfectly. Learned a very cool new trick. Very professional & well explained & clear vid. Great job man. Thx again
Just had to listen to two we're super mechanics blah blah never seen a wheel like this etc. 3 min later after watching your video, hey guys try this. Ahhhh the look of blank faces, its the little things in life😁. Thanks for the tip 👍
Haha very true. Glad it helped. Please like and subscribe as it helps my channel supporting charity :)
Dude u r a genius!
I try different things lol
Tried it. Does not work when you have a flat tire. But this will become handy when i need to rotate my tires. Thanks!
You're right does not work for flat Tyre.. what l had to do was slack the lugs.take out jack..start the engine.drive a couple second turn right and left, then you'll hear a snap.. it's free.. just letting you know..!!
I usually jacked up the car put a piece of wood or flat rock on the inside bottom of the tire and lower it down with the lug nuts LOOSE so the weight of the car will pop it out . It works most of the time but right now it didn't so I'll give this a try Thanks 👍
Let us know if it worked this way
Worked like a charm, thank you 🤙
Glad it helped. Please like and subscribe as it helps my channel support charity and yes you can support it too by donating to PayPal id: Dewana421@aol.com. No amount is small :)
Yep works all the time you may have to do it once or twice maybe rotate the wheel a little as you do it but it is the best way good job my man
Thank you so much for sharing this big help with my stuck tire rim
Glad it helped. Please like and subscribe as it helps my channel supporting charity :)
Thank you so much! I did the drive around the neighborhood thing and I finally got the wheel off.
NOPE! Had to jack it up and put a board against it and whack it from underneath with a sledge, 3 heavy whacks.
Excelente idea.
Muchas gracias hermano.
Thanks for the ideas - I've struggled with this with other cars and I need to remove a wheel from my wife's car to repair a flat - will try!
Good luck. This works 100%
Worked perfectly, thank you
Glad it helped
When I got Flat on the highway, my tire was STUCK STUCK. Literally everything tried failed, I even put it back down, no lug nuts on tire and drove forward and backward & tht wouldn’t even work. A cop stopped and said he’s never seen a tire so stuck before, I resorted to using a hammer & after few hits it finally came off. WHY do tires stick like that??!
Because they should have antiseeze between them and rotors but someone didn’t put it and if you don’t rotate your tires for a while then it stays there long and fuse together due to corrosion and moisture.
I got a flat on my Audi a4 2007 back tire and its stuck like this, do i need a tool to removed the center piece or do i the exact same thing you did in this video? Im super confused!
I want to make sure I understand what you did. You jacked up your car, took off all the lug nuts, then loosely hand tightend 2 lug nuts, then you jacked down the car, then the wheel came off. Did I get everything right?
Yes correct. In some cases it still doesn’t come out like then the best way is to loosen your all 4 lug nuts (not all the way loose but like 2 hand turns so it’s loose but still holding wheel - after you loosen it by wrench). Then jack it down and then drive a little and the wheel will come loose. Just make sure it’s not so loose that the wheel comes off or gets wobbly. It should just be enough to loosen it off but keep the wheel in place.
Thanks for posting this. I was unsure how to proceed. I had to raise and lower it a couple times and then a couple kicks, but it popped loose. Thanks again.
Glad it helped. Please like and subscribe as it helps my channel supporting charity :)
Thank you, short sweet video and it worked. Appreciate the video it saved me from taking an aspirin…. LOL.
Glad it helped. Please like and subscribe as it helps my channel grow:)
Great tip, thank you so much!
Glad it helped
worked perfectly, thx, need to slowly lower the jack tho
Glad it helped. I agree but it was a junk car so I cared less being slow lol
Thanks for mile travel tip with the nuts slightly loose 👍
Thank You for posting ! Saved me a lot of time! 😅
Nice video short and to the point thank you
Thanks man! That did the trick.
Glad it helped. Please like and subscribe as it helps my channel supporting charity :)
You are a GENIUS! GREAT HACK. THANKS!
Thanks for the idea good help!!
I wish I saw this 1 hour ago lol
I'll go try now and let you know how it goes!
Thanks man. Really appreciated.
Glad it helped
Thank you
Glad it helped. Please like and subscribe as it helps my channel grow:)
HUGE help. Thanks!
Glad it helped. Please like and subscribe as it helps my channel grow:)
Thanksalot! This video saved the day!
Glad it helped. Please like and subscribe as it helps my channel supporting charity :)
Worked a charm, cheers 👍
Does it bent the brake rotor if you do that?
Not at all
Thank you sir...this saved me today!
Very helpful
Thank you man!!!!
Glad it helped. Please like and subscribe as it helps my channel grow:)
Gr8 job my friend
Thanks for the visit
Very Effective technique
Brilliant! Thanks Brother!!!!!
Glad it helped. Please like and subscribe as it helps my channel grow:)
Just spent 20 minutes trying this, my dad comes along, sprays WD-40 into lug nut holes, jacks up the car and uses a rubber hammer to hit the back side of the wheel outward, literally one hit
Thank u this video saved me today
great help. thank you.
It really works! Thanks a lot!
Glad it helped. Please like and subscribe as it helps my channel supporting charity :)
Thank you! I just yesterday had to bang my rear wheel off with a sledgehammer
Did you use a wedge or no?
Nope
@@HowToDoitright Hmmmm... I think I will need to use a wedge...
@@HowToDoitright injector on the vehicle?
What do you mean? I’m confused of your question
@@HowToDoitright nevermind, I used a wedge. It worked.
The problem is that my tire is flat and I don't think this would work for me :(. I've been waiting 4 hours for AMA to get road side assistance lol.
What I can recommend is jack up your vehicle after loosening up all the bolts and make sure you lose it enough, but don’t take them off and then put the jack down suddenly and that will loosen up your rim. If you cannot take it down suddenly, then slowly would work too.
THANK YOU
Cheers I'll try this.
I had a stick wheel,and freed it by driving with loose wheel nuts.
Beautiful tech8
Worked for me thank you
Glad it helped. Please like and subscribe as it helps my channel supporting charity :)
🎉🎉🎉
It worked!
Just saved my ass! Thank you
Thanks works like a charm
Wow
Reporting back. It work for me. I actually had to do the second option mentioned, just forward and backward in the driveway. I'm an anti-seeze believer now.
U saved a life!!!! Lol
Glad it helped. Please like and subscribe as it helps my channel grow:)
Didn't work for me, too much flex in the tyre.
fuck bmw my x5 front wheel does want to come out no matter what i do even i drove it without bolts for 10 miles and still wont come out. fuck this shit
Oh I know an easy way. I made a video on my channel. Check it out.
Didn't work for me :(
Nope. Didn’t work. Any other ideas?
Did you loosen you wheel nuts enough and drive around. Make sure you go over some bumps and off-road. This should def do the trick.
Didn’t work😢
Eh this does not work if the tire of flat…
Then fill it up with air and do the same it will work.
@@HowToDoitright lol i guess you have never had a flat tire before lol
@@thomasmaher6880 I did but I always keep a repair kit in my car and it takes me 5mins to repair a flat…and I don’t take my wheel off to repair a flat. Those plug-in kit works wonders.
@@HowToDoitright I agree, but you missed the point.
@@thomasmaher6880 what was the point?
Did not work unfortunately
Just hit it bro!!
Holy shit boomers
IM trying to find that clip where this 3 digit guy is using a lever but I can only land on these memers
Trust me bro hitting didn’t work. I hit this like crazy. You don’t want to hit it too much either or you will mess up your alignment.
Even this is not working for me
You must loosen the bolts a little and drive around on bumps and it will come loose. Just make sure bolts are not way too loose. Just enough
@@HowToDoitrightThats what I'm gonna try next. Thanks