How to troubleshoot Extruder barrel heater not heating up temperature.

Lead hand complain on extruder barrel heater zone 1 temperature not going up, troubleshoot found the problem issue and fixed.

[@Nicofish2023]

Thanks. More videos like this please

[@tmelectricaltutorials2851]

More to come!

[@victordelacruz4906]

Mahusay talaga kayo sa troubleshooting master you are my idol

[@tmelectricaltutorials2851]

Salamat idol ❤️

[@danielbartolome8807]

The best ka talaga master sa troubleshooting. Ganun pala pag check ng fuse kung may power may natutunan ako., thank you 🙏

[@tmelectricaltutorials2851]

Thank you idol

[@aizaenriquez3990]

Napaka galing nio talaga master s teoubleshooting......👌👌👌👏👏👏👏👍👍👍

[@tmelectricaltutorials2851]

Thank you idol

[@leondioquino4241]

Good job master galing 👍

[@tmelectricaltutorials2851]

Thank you bro

[@jaykesapalaran5434]

Thanks for teaching knowledge sir ... God bless po.🙏

[@tmelectricaltutorials2851]

Your welcome jayke

[@tranginh3912]

thank you !

[@tmelectricaltutorials2851]

You’re welcome

[@ron514ron]

good job kapatid 👊🏻

[@tmelectricaltutorials2851]

Thank you kapatid

[@jesusgarzon5773]

How would you tell if a thermocouple is working properly for these machines?

[@tmelectricaltutorials2851]

the reading on the screen doesn’t rich set point if termocouple problem.

[@kitscastillo9187]

Pano naman sir pag di bumaba temperature ng upper die zone namin? Set point is 360 but set value is 450

[@tmelectricaltutorials2851]

kung sa die at ng overheat kadalasan ang contactor na stuck stays on kaya kaya ng overheat. dati kahit d nmin shut down line off ko breaker para mapalitan contactor pero ngayon for safety shutdown ang line at lockout . palitan ng contactor.

[@tmelectricaltutorials2851]

kung hindi stuck ang contactor minsan ung thermocouple yung dulo hindi naka dikit sa bakal pihitin pra dumikit sa ilalim ng die.