Polaris Ranger 500, How To Rebuild Carburetor, Carb, Will Not Idle, Start, Will Not Run, Accelerate

Поделиться
HTML-код
  • Опубликовано: 23 ноя 2024

Комментарии • 14

  • @louiscormier12
    @louiscormier12 Месяц назад +1

    This was amazing, thank you!

    • @crankitt825
      @crankitt825  Месяц назад

      You’re very welcome!! Glad we could help you out.

  • @stonersweet420
    @stonersweet420 2 месяца назад +1

    Thank you that was super helpful

    • @crankitt825
      @crankitt825  2 месяца назад

      You’re very welcome. Glad we could help you out!! Be sure to like and subscribe.

  • @manuelsegura9253
    @manuelsegura9253 Месяц назад +1

    Do you have a video how to install choke cable and adjust it

    • @crankitt825
      @crankitt825  Месяц назад

      I don’t think I have. I will try to make one the next time I have one in the shop.
      Thanks for watching our videos!!

  • @chinky1269
    @chinky1269 5 месяцев назад

    Very good video, thank you for the info!

    • @crankitt825
      @crankitt825  5 месяцев назад

      Glad it was helpful! Be sure to like and subscribe to our channel.

  • @robertorrison6664
    @robertorrison6664 5 месяцев назад +1

    very good video

    • @crankitt825
      @crankitt825  5 месяцев назад

      Thanks for watching and glad we could help. Be sure to like and subscribe to our channel!!

  • @robertgonzales5515
    @robertgonzales5515 10 месяцев назад +1

    Awesome video. The information is extremely helpful. I been working on a LT200 American works side by side for an elderly couple. The engine is 1500cc it had carburetor issue in the past.
    The poor elderly have taken it to a dealer and choke assembly had been replaced. it ran for a while and quit running. Then a family member tried working on it and to no avail. it was brought to me in a complete mess (parts missing). It runs for seconds and then dies. checked all electrical parts and appear ok. it has symptom of gas starvation I disassemble the carb and the it had been taken apart in the past. it was reassemble with super glue. I replaced the carb with a new including a new intake. it does'nt idles . it runs while operating throttle . any suggestions will be appreciated .

    • @crankitt825
      @crankitt825  10 месяцев назад

      Sounds like you’re still having trouble with fuel. I would clean the carb and check my fuel and air mixture screw.

  • @christophersautter5002
    @christophersautter5002 3 месяца назад

    Hello, I was wondering if you know the model # for the carb so I can find a rebuild kit for it from minuki. I’m having trouble getting my 2003 500 6 x 6 to start and I have spark, the plug is wet and compression and I’m less than 20% on a leak down test so it should be starting. I have come to the conclusion that it’s probably a bad carburetor since they had an aftermarket on, so I’m trying to rebuild the original one to see if it starts then I think that the Aftermarket one is messing up the air fuel mixture to get it to even start. Thank you so much for any help that you can give.

    • @crankitt825
      @crankitt825  3 месяца назад

      Thanks for watching. Sorry I don’t have the model number for the oem carb. Call the dealership and they can get you the original parts. Be sure to like and subscribe.