Building RatRig V-Core-4 IDEX 3D Printer: Part 4 - Installing Belts and Build plate

Поделиться
HTML-код
  • Опубликовано: 23 дек 2024

Комментарии • 16

  • @BackwoodsTinkerer
    @BackwoodsTinkerer 10 дней назад +1

    You're not alone. Hopefully Cruz adds some clarification in the documentation. I highly suggest checking the comments on any step that have any before performing that step. Lots of helpful feedback from other users

  • @hedleypepper1838
    @hedleypepper1838 12 дней назад +1

    Please continue your videos as you use the printer..... good job 😊

  • @thebrigandier
    @thebrigandier 14 дней назад +1

    Thanks for the guide. Having some familiarity with the machine is going to be huge during the build process.

    • @RocketkidDesigns
      @RocketkidDesigns  13 дней назад

      Happy to help, I'm really glad I might be able to make your build go smoother.

  • @antonbuharin
    @antonbuharin 10 дней назад +1

    For the belt routing: If you have another printer then instead of zip tie print a 200x9x0.4mm stripe, so much easier to route. Got it from Mandic labs

  • @theolivegrove342
    @theolivegrove342 14 дней назад +2

    I had to pause the video. I'm half way through and I'm sitting here fully absorbed in the material. I keep thinking 'I wish more of my college professors taught/delivered information like you do. I might have enjoyed the courses more. Thanks for another quality video. Did your other printer show up? Are you going to make a video on it also?

    • @theolivegrove342
      @theolivegrove342 14 дней назад +1

      "Patience waning"🤣😆 Thanks for humanizing the build process.

  • @DarkangaelBrokenwing
    @DarkangaelBrokenwing 13 дней назад

    Thank you was looking into building a printer. Did you like the result?

  • @Rmilyard
    @Rmilyard 5 дней назад +1

    When doing next video?

    • @RocketkidDesigns
      @RocketkidDesigns  5 дней назад

      Working on it now probably will be one or two days still. Work has been super busy so I got behind on the videos.

  • @kazolar
    @kazolar 10 дней назад +1

    I hope that bed is flat, the bed plate seemed kinda wobbly, unless your worktable is less than flat

    • @RocketkidDesigns
      @RocketkidDesigns  10 дней назад +1

      Yeah I was concerned for a second but the bed was perfectly flat I think there was a piece of wire insulation or something that was under it that I didn't notice at the time.

  • @Rmilyard
    @Rmilyard 10 дней назад

    OMG this is a nightmare!

  • @AshleyLiu-h9g
    @AshleyLiu-h9g 6 дней назад

    wanna have a collaboration