Check out Aksmanisyak’s channel. He has the link for the transom mount which is just some plastic cutting boards. But the Tarpon 120 has that weird cutout in the back I think for a rudder…? I ended up using a door sliding lock/latch from Home Depot to fit into that carve out. Then that gave me a flush surface to mount the plastic cutting boards.
Hi there; l have the same kayak and lam experiencing the same problem that you show with PWM more power is back? Can you help me with that it will be appreciated thanks
The easiest way would be to mount the power dial on the other side of the kayak. So that when you dial it forward, it gives more power. I’m right handed so I just installed it on the right side of my kayak. Installing it on the left side would give you the opposite effect. It’s not a big deal, I got used to it. I’d go with comfort over logic on this one.
Sweet rig! My wife has the same kayak, and I was looking at doing this same mod. This was very helpful, thanks a ton!
Hell ya that’s actually really good set up
nice setup...!!! good job.
About how much battery life are u getting
Plenty!
100% power I can get 4 hours @ 5-6mph.
90% 5-6 hrs @4-5 mph
80% 6-7 hrs @ 4mph
70% 9-10 hrs @ 3mph
How did you extend the cables for your pwm
Spliced the wires. Cut the ribbon and spliced each individual wire. It was time consuming and tedious.
Yea how much battery life do you get?
Plenty!
100% power I can get 4 hours @ 5-6mph.
90% 5-6 hrs @4-5 mph
80% 6-7 hrs @ 4mph
70% 9-10 hrs @ 3mph
Where did you get that mount I have the same exact kayak
Check out Aksmanisyak’s channel. He has the link for the transom mount which is just some plastic cutting boards. But the Tarpon 120 has that weird cutout in the back I think for a rudder…? I ended up using a door sliding lock/latch from Home Depot to fit into that carve out. Then that gave me a flush surface to mount the plastic cutting boards.
What pwm and power meter did you use? I’ve been looking on that other guy’s channel and can’t find what you’re using.
a.co/d/f5w3R3n
Thank you! And what about the screen that displays volts, amps, and amp hours?
@@CrayonEater815 a.co/d/hSG0iGz
@@CrayonEater815no problem!
Hi there; l have the same kayak and lam experiencing the same problem that you show with PWM more power is back? Can you help me with that it will be appreciated thanks
The easiest way would be to mount the power dial on the other side of the kayak. So that when you dial it forward, it gives more power. I’m right handed so I just installed it on the right side of my kayak. Installing it on the left side would give you the opposite effect. It’s not a big deal, I got used to it. I’d go with comfort over logic on this one.
@@funkymonkey0009 What l was trying to tell you is when l turn on after the knob click is on full power
@@antoniodominguez5861oh so the knob isn’t working for you? No matter where you turn it, it is always 100%?
@@funkymonkey0009 IIt is working, but after the click on starts on full speed when suppose to start on cero
and if l turn the power decrease
is working but on backwards