How to Install Geotab's GO Plug-&-Play Vehicle Tracking Device
HTML-код
- Опубликовано: 2 май 2016
- Learn how to install Geotab's GO Plug-&-Play Vehicle Tracking Device quickly and easily. Follow four simple steps, and within minutes your Geotab fleet management device will be out of the box and hard at work for your business. This installation doesn't require any special tools or the assistance of a professional installer - you can do it yourself.
Find the printed installation guide for the Geotab GO Plug-&-Play Vehicle Tracking Device at: www.geotab.com/installation-d...
To check the status of your installed Geotab GO Plug-&-Play Vehicle Tracking Device, visit: myadmin.geotab.com/install.htm
The Geotab GO Plug-&-Play Vehicle Tracking Device is a fleet management device that delivers advanced vehicle data and premium tracking at affordable rates. To discover more about what the GO Plug-&-Play can do for your business, visit: www.geotab.com/wp-content/the...
Learn more about the fleet management solutions from Geotab and find an authorized Geotab Reseller: www.geotab.com 
Наука
video anda sangat bagus dan mempunyai mesej yang luas terima kasih
I have one of these in a 2016 Tacoma that belonged to Orkin. Can I cut it out without it shutting off the truck?
…..Yes, unplug the MF’er, and plug it back in when ready to leave. Don’t accidentally leave it on the table at a str*p bar though.
We had network fleet for our chevys and damaged the computer. Great job.
…I believe it F’d up my 2006 Camry. The airbag light stays on now. The ABS light comes on occasionally, but only when the GEO tab is plugged in. Domino’s forces us to use one.
it only draws current..
and how would it be if the obd-II port had to be used to diagnose the units, since it would be invaded with the device
Can't do much about it with this type of install, BUT Geotab does offer T harnesses that will allow hiding the device in the dash and leaving a vacant OBD port under the dash.
How do I stop the signals
Beeping usually goes away after three ignition cycles as the device exits test mode. Any additional beeping is set up through your account portal.
…I had mine beep 20 to 30 times and I was going down a straight road at 10 mph, not breaking any laws. Tons of time it will beep for no reason
…Smash it with a hammer, just like Hillary Clinton did with her computers and cell phones to avoid going to prison
My GO7 device loses communication after the unit is stopped and / or off for 2 days, how can I remotely reset it?
How to solve the problem?
Greetings from BOLIVIA - LA PAZ
….Just Praise the Lord it doesn’t work. It F’d up my car
Hmm it's pretty easy but your installer didn't even tighten the blue zip tie! :(
Dont a gps signal blocker pluged in the ligher stop it
And it dont work under bridges 4 sure w/o blocker
I saw that...made the zip tie look trifling
Static bags cuts out the blue light 😂
0:21.
This one is Too obvious .
Should be called Nanny GPS ...
….It’s worse than a Nanny. At least you can look at the Nanny’s boobs
that might be the worst ziptie job in the history of installs
…And the mechanic will just rip it out when he needs to analyze your engine