how to test for short in fluorescent light starter

Поделиться
HTML-код
  • Опубликовано: 25 окт 2024

Комментарии • 20

  • @fab-antonio
    @fab-antonio 3 месяца назад

    Great tip. Right to the point. Thanks.

  • @davidwalker2781
    @davidwalker2781 2 года назад +7

    What is the SETTING, on your meter for this starter test.??

    • @christhurman9102
      @christhurman9102  2 года назад +2

      It's on the ohm scale

    • @christhurman9102
      @christhurman9102  2 года назад +1

      That will also show any resistance across the condenser,capacitor

    • @jdvusexpat
      @jdvusexpat 2 года назад

      @@christhurman9102 what setting on the Ohm scale is proper?

    • @christhurman9102
      @christhurman9102  2 года назад +2

      I start out on Rx1 then move to Rx100

    • @ahmedsaied376
      @ahmedsaied376 Год назад

      I have digital avometere.. how can know ??

  • @RobertGeissel
    @RobertGeissel 5 месяцев назад

    Hello just started to refurbish an old Falstaff sign, where can you get a SP-4 4w . 125 amp ballast and lamp for my sign? Thanks

  • @robertanderson4913
    @robertanderson4913 Год назад

    very helpful ! , thanks ! 2:03

  • @Gary-ts6dh
    @Gary-ts6dh 2 года назад +1

    1:22 - Do you know the capacitance of the condenser? Are there different values for FS-4, FS-2, etc?

    • @christhurman9102
      @christhurman9102  2 года назад

      Only on the glow switches,most capacitors , condensers are around .001 to .0047. anything around that up to .01 will work working volts usually 200v or higher but that's not too critical just don't go too low on the working volts,

  • @mantolaman
    @mantolaman Год назад +1

    What if the glass tube is all black? Starter shows no short, but won't make the light come on.

    • @christhurman9102
      @christhurman9102  Год назад

      Yeah then I would say the glow switch is bad that is the glass tube.,They can still work even if the glass is totally black ,but if the light still won't start,then,yeah ,it's most likely bad .

    • @mantolaman
      @mantolaman Год назад +1

      @@christhurman9102 Thank you. I can't really be sure what the issue is. I tested the lights and they have about 6 ohms resistance too.

    • @christhurman9102
      @christhurman9102  Год назад

      @@mantolaman yes a new starter or a new glow switch in the old starter should fix the problem

  • @dhh488
    @dhh488 2 года назад +1

    Thanks, mine was shorted. It isn't mine really, my brother had a bar light that wasn't working and asked me to look at it.

  • @chaseedwardsedwards540
    @chaseedwardsedwards540 Год назад

    In most cases the condenser shorts out and by removing the condenser, the starter will work again until the neon tube itself fails

  • @carlthornton3076
    @carlthornton3076 2 года назад +1

    Very Good!... #8 ✝ {6-17-2022}