Poulan Pro 405 Plus Full Assembly & Test Run...Plus Pioneer/Poulan Pro Logo Design Discussion!

Поделиться
HTML-код
  • Опубликовано: 10 июл 2024
  • 0:00-Intro
    1:45-Paint Polishing
    10:50-Crankcase Prep
    13:40-Non-Captured Cylinder Nuts
    15:25-Clutch & Oil Pump Cover Removal
    18:00- Piston Installation
    27:15-Cylinder Installation
    39:00-Oil Pump Cover Installation
    40:30-Flywheel Installation
    42:15-Clutch Installation
    43:20-Lower Isolator Replacement
    49:15-Lower Handle/Engine Installation
    51:45-Coil Installation
    53:00-Pioneer/Poulan Pro Logo Discussion
    54:00-Kill Switch Wire Installation
    56:00-Throttle Handle Installation
    1:02:00-Muffler Installation
    1:03:00-Spark Test
    1:05:00-Starter Installation
    1:06:50-Compression?
    1:07:30-Carburetor Inspection & Installation
    1:15:00-Test Run

Комментарии • 9

  • @thomasfrost6993
    @thomasfrost6993 Месяц назад +1

    Congratulations on your "new to you" saw. I can tell you're quite excited about it. I just picked up a Husqvarna 272XP and plan to rebuild it later this year. Can't wait. It'll be fun to see the 405 in action.

  • @wrayjordan8315
    @wrayjordan8315 Месяц назад

    See who remember this vehicle.
    My dad had a 1959 Chevy Nomad station wagon two tone. He called it cowsh?t green and catsh?t yellow. The Poulan Pro has a similar yellow!

  • @wrayjordan8315
    @wrayjordan8315 Месяц назад

    Great looking saw!

  • @MegaKelcat
    @MegaKelcat Месяц назад

    Just in the case you ever needed to they can be welded. I have a P-51 that someone before me repaired and seemed to have nice bead on both sides of the repair.

  • @bobbynash282
    @bobbynash282 Месяц назад

    I believe thats chicken s@#t yellow, according to my mother inlaw. Thanks for sharing it with us. Almost like watching a movie.

  • @julianbenzaia6325
    @julianbenzaia6325 Месяц назад +1

    The P39 doesn’t have the cut-out on the left half of the crankcase to allow air to go up into the boost port. Without it, the opening to the boost port on the base of the cylinder is blocked.

    • @markjefferson8788
      @markjefferson8788 Месяц назад

      That's right. I didn't get a good look at the piston, but it has to be the "windowed" type to work with that cylinder as well.

    • @LeonsChainsawPartsAndRepair
      @LeonsChainsawPartsAndRepair  Месяц назад

      I appreciate this...that machining difference on the left side of the crankcase was something I missed!

  • @markjefferson8788
    @markjefferson8788 Месяц назад

    Those Walbro WJ carburetors are notoriously difficult to tune. The high and low circuit are in tandem. You just about have to have it in the cut while someone tunes the carb.