Lmao so youre the type to go at it with a nine inch and not pep worth of shit. Speaks volumes bud. If you cant throw down for one, stop whinin ab it. 😂😅
@@devinnorsworthy9154you don’t prep a job site at all? No taping….nothing on ground just in case a drop of paint hits the floor….I am a professional and still prep sites somewhat….
I've painted for many years, just never got into spraying until recently and I just got a Graco magnum x5 to start out with until upgrading later and absolutely love it! The finish and work flow is unbeatable for the price!
@@Lost1st as long as you use the proper spray tip for each job and type of paint I havent had to back roll anything. ALWAYS strain your paints every time before using them and keep the gun moving as even as you can. If you get any heavy areas or runs/drips, which is perfectly normal, you can back roll them or brush them out. Its better to do 2 light-medium coats than 1 heavy also. Good luck👍👍
Will this show streak lines after it dries? I am having that problem with a 9 inch and 18 inch roller! I have done back rolling and only go off the wet edge but it still keeps showing roller marks. At the same time its newer drywall and the person who installed used wrong mud technique and sanded wrong. I used primer and it showed no streaks at all!
U get better and faster at prep as you go. What use to take u 3-4 hours will take u an hour in time. Well worth it for the finish and back pain you are going to save yourself
Yes it quicker spraying but it definitely way longer then when you add in the covering the floors and masking&taping the part that actually makes the difference in paint process 😉
Masking does suck but if you do it a lot you get pretty fast at it I masked off a room in about an hour and sprayed the entire room in 30 minutes I suck at cutting in as it drives my patience in especially under window trim
I love spraying... been spraying houses for 22years, baseboards and ceilings and exteriors... walls on the other hand I always prefer to cut and roll. It ends up being way faster if you're already a good painter. If not, you're gonna be slow either way.
I don’t mind the prep but my X5 makes a huge mess. Even at low pressure half the paint goes on the wall and the other half just stays in the air in the air and lands on the walls and floor as a sticky dust. I haven’t figured out how to spray a room without a cloud of paint lingering in the room.
Yeah , how long was it to move furniture put plastic blue tape paper cover floors, remove paper, remove ,remove plastic, sanding, patch picture holes , clean yours sprayer oh and waiting to dry between coats ?? 😀👍🏼
@@trashpanda2396 It evens it out. Gives it a consistent texture. When it's sprayed, it is very inconsistent in how much is applied to different areas. Where the spray overlaps, it will be heavier and there will be lighter areas just due to the nature of spraying. If you look at an angle in daylight, you'll see every sweep of the spray. If it's not dead flat paint, where it's heavier, will be shinier. No competent painter will not backroll!
@philc8575 good to know I just sprayed a rental. Walls look great. Ceiling has a bit of lines and it drives me crazy but I couldn't roll it. It was like fiberboard with 1½" slats covering the seams
Pretty sure that isn’t a paint respirator mask. (The paper ones are generally gray and look heavier.) Atomized water-based products are bad,maybe worse,for your lungs than oil based.
Water based paints pollute the environment even more than solvent based. People have the crazy idea that water based can be dumped down the drain. (Automotive, aerospace and even woodwork water based are very bad for operators health).
@@philc8575 wish you best day ever feeled with happy times and good energy and have fun when painting cause i do mural art and know how it can be time consuming to do a good job and take time too so thank bro maye God Bless you
So you can create lap marks, overspray, waste paint, and have to roll a final coat in the end anyway...at least you look cool in your little yt short. 😂
You took longer putting all that plastic and tape just to spray a couple walls I would’ve brushed and rolled, would’ve left a nice cut in, better texture than a fine finished… Even if sprayed the I still would’ve back rolled those walls as I went along Rookies…..
![I.N "HALLUCINATION" | [Stray Kids : SKZ-PLAYER]](http://i.ytimg.com/vi/n5B5q1Hwt_U/mqdefault.jpg)
How much time did it take you to move furniture and prep. 2 days
Well same it would take any other way to paint.
Три
What if it's new construction? 🤦♂️
Lmao so youre the type to go at it with a nine inch and not pep worth of shit. Speaks volumes bud. If you cant throw down for one, stop whinin ab it. 😂😅
Spoken like somebody who has never painted anything.
That's awesome now show prep time and prep material cost versus cutting in and rolling
Yup, I can cut and roll without prep.
@@devinnorsworthy9154probably have a ton of tiny little droplets all over your trim. But more power to ya
@gavinwright9849 I haven't seen any, any you do see use the rag you have on your side...
@@devinnorsworthy9154you don’t prep a job site at all? No taping….nothing on ground just in case a drop of paint hits the floor….I am a professional and still prep sites somewhat….
I've painted for many years, just never got into spraying until recently and I just got a Graco magnum x5 to start out with until upgrading later and absolutely love it! The finish and work flow is unbeatable for the price!
Any problems like everyone in the comments claiming? I have the X19 and about to do my home.. curious on if you had to "back roll"
@@Lost1st as long as you use the proper spray tip for each job and type of paint I havent had to back roll anything. ALWAYS strain your paints every time before using them and keep the gun moving as even as you can. If you get any heavy areas or runs/drips, which is perfectly normal, you can back roll them or brush them out. Its better to do 2 light-medium coats than 1 heavy also. Good luck👍👍
Well done ... I'm just hoping you're not back rolling..just the last coat you roll
@@Lost1st if you back roll you are just removing paint. Spray one wall and spray and backroll another.. you will see what I mean...
Will this show streak lines after it dries? I am having that problem with a 9 inch and 18 inch roller! I have done back rolling and only go off the wet edge but it still keeps showing roller marks. At the same time its newer drywall and the person who installed used wrong mud technique and sanded wrong. I used primer and it showed no streaks at all!
Time to spray 6 minutes. Time to prep crown, floors, baseboards, doors and casings; 3 hours.
3 hours? He wishes
3 hours? Hahah. No
3 hrs ? Lol
Still faster than rolling and cutting
how do you prep the ceiling?
U get better and faster at prep as you go. What use to take u 3-4 hours will take u an hour in time. Well worth it for the finish and back pain you are going to save yourself
No way! That was quick!
Yes it quicker spraying but it definitely way longer then when you add in the covering the floors and masking&taping the part that actually makes the difference in paint process 😉
Masking does suck but if you do it a lot you get pretty fast at it I masked off a room in about an hour and sprayed the entire room in 30 minutes I suck at cutting in as it drives my patience in especially under window trim
The cost too for the tape and plastic sheets and paper on the floor etc
A professional would be covering the floors like that no matter if they are spraying or rolling and brushing.
Can you do this kind of spraying (heavy wide spray patterns) with an HVLP like the Fuji Q5?
For someone remodeling this would save a lot of time since the room is already empty and floors aren’t installed yet.
what is the difference between X5 and A30 ?
I love spraying... been spraying houses for 22years, baseboards and ceilings and exteriors... walls on the other hand I always prefer to cut and roll. It ends up being way faster if you're already a good painter. If not, you're gonna be slow either way.
Does the sprayer come with a clock?
Note add prep time for the overall time and its comes out to be the same amount of time just difference in finish
Prep time. Unmask, system clean. Not a hater. Like spray. Just add it in.. what is that number?
are you using LP tips?
I don’t mind the prep but my X5 makes a huge mess. Even at low pressure half the paint goes on the wall and the other half just stays in the air in the air and lands on the walls and floor as a sticky dust. I haven’t figured out how to spray a room without a cloud of paint lingering in the room.
Thicker paint. Good ventilation. Or low pressure
@@joshualongden7047 I have the same issue what paint do you recommend?
@@trustmeimadochad this issue with crappy aftermarket tips. Switched back to oem graco, pleasure to spray again…
Yeah , how long was it to move furniture put plastic blue tape paper cover floors, remove paper, remove ,remove plastic, sanding, patch picture holes , clean yours sprayer oh and waiting to dry between coats ?? 😀👍🏼
Exactly.
How long did it take to tape everything off??
You forgot to include the prep time
Where is the overspray? No mask??
😂 get some shields and helper and cut 2/3 prep
Now show the time to tape everything. ALSO show all the time to clean up the device. You end up with the exact same time frame
5 1/2 mins to spray 30 mins to prep 😂
I do love spraying over brush because
1. It’s Fun
2. More even coverage
3. No brush / roller marks
*hours
30 minutes??? 2 hrs
And 3 hours to roll. Spoken like a true moron
Acctually your equation is not far. Preparation usually takes much longer regardless of rooling or spraying.
Now backroll it!
Just another rip off painter!!
I was going to say the same no backroll crazy
What does backrolling do?
@@trashpanda2396
It evens it out. Gives it a consistent texture. When it's sprayed, it is very inconsistent in how much is applied to different areas. Where the spray overlaps, it will be heavier and there will be lighter areas just due to the nature of spraying. If you look at an angle in daylight, you'll see every sweep of the spray. If it's not dead flat paint, where it's heavier, will be shinier. No competent painter will not backroll!
@philc8575 good to know I just sprayed a rental. Walls look great. Ceiling has a bit of lines and it drives me crazy but I couldn't roll it. It was like fiberboard with 1½" slats covering the seams
What is this obsession with speed now, I don't get it. Take the time to do it right.
Great for student housing.
Yea but what about how long the prep work took?
Pretty sure that isn’t a paint respirator mask. (The paper ones are generally gray and look heavier.) Atomized water-based products are bad,maybe worse,for your lungs than oil based.
Water based paints pollute the environment even more than solvent based. People have the crazy idea that water based can be dumped down the drain. (Automotive, aerospace and even woodwork water based are very bad for operators health).
Not a respirator. Doesn't care. Doin' a video for graco. Eating paint.
NOOO...QUEREMOS RAPIDES.... QUEREMOS UN TRABAJO BIEN HECHO
36 hours of prep.
Don’t forget to back roll
I wish I could do that and not breath the paint particles and not get it all over me.😅
Safety first..
Why spray? The bigger question is why prep for two days 😂
You can have 6 guys rolling a wall and I can spray out the same wall in half the time plus I get better coverage... that's why
In the famous words of Maela
“Quien te dijo que eres pintor?! Eh eh eh!
Um, excuse me, where is your roller? No stipple no touching up without bubbling the entire house off for 1 stupid patch. Smh
30min.+ 2hours back roll.
This cannot have a good even Finish ! Need to ha e second person to back roll ! Maybe okay for rental or builder but not for custom work. Sorry Graco
You nailed it. This POS gives good painters a bad name!
Put up ACTUAL TIME from start to finish... prep(taping and covering EVERYTHING), setting up sprayer. ZERO time saved.
Плюс 5 часов на "обклейку"!
1, 2 комнаты, валиком быстрее.
Too much prep✓ Roll/Cut🤟
Se tardo más en empapelar
Work paint
Speed dont meaning a good work
The manufacturers lied and never warned us about mercury!!!
@@philc8575 wish you best day ever feeled with happy times and good energy and have fun when painting cause i do mural art and know how it can be time consuming to do a good job and take time too so thank bro maye God Bless you
Backroll
Totally worthless video for us retired people.
How many hours to prep????
No back roll???
No respirator???
B.S😅
Only amateurs back roll. Because they can't spray without getting runs
@@JONO3679it’s not all about runs. It’s about being able to touch it up later
@@JimmyMyJimmy thats why you always roll the last coat
So you can create lap marks, overspray, waste paint, and have to roll a final coat in the end anyway...at least you look cool in your little yt short. 😂
How long to mask tape all this buahaha and then back to ceiling painting, and touch up paint bleeding under tape haha love those amateures
Oh no Jesus he secure ceiling with plastic
This painting it's a waist of time of the year
Dude is too slow to work for me!!!
No
Perfect for me 🫡saving some money
You took longer putting all that plastic and tape just to spray a couple walls
I would’ve brushed and rolled, would’ve left a nice cut in, better texture than a fine finished…
Even if sprayed the I still would’ve back rolled those walls as I went along
Rookies…..