How To Replace The Centre Brake Light Audi TT Mk2

Поделиться
HTML-код
  • Опубликовано: 13 дек 2024
  • In this video i demonstrate how to replace the centre LED brake light on an Audi TT Mk2. you will need some basic hand tools and i used some plastic trim tools to help remove the light unit. It's bolted and sealed in with a sticky seal.
    #Audi
    #TT
    #Mk2
    #brakelight
    #LED
    #Howto

Комментарии • 57

  • @nigh7swimming
    @nigh7swimming 3 года назад +10

    Tip: do a test fit before removing tape and exposing the glue. You want the part to sit near the bottom rather than near the top where the spoiler is.

  • @umeshsinghal6250
    @umeshsinghal6250 3 года назад +4

    Thanks for creating this video it helped me so much! Tip for the automatic spoiler owners is to lift it up!

  • @wudza
    @wudza 7 месяцев назад +1

    Thanks for posting this video. I have just replaced the centre brake light on my wife’s TT. I would never have done it without this video. 👍👍👍 cheers

  • @popeyedoyle1976
    @popeyedoyle1976 9 месяцев назад +1

    This was so helpful. Just used it to replace the light on my TT. Thank you!

  • @harjasfsmailnet
    @harjasfsmailnet 2 года назад +3

    Excellent video, thanks so much. I kept putting this off as my light needed replacing for months. I did it in 30 mins following this video and the most time consuming part for me was talking the old light out lol. Awesome video and so easy to follow :)

  • @peterbraybrook4166
    @peterbraybrook4166 3 года назад +6

    Great video and very helpful but two extra words of advice. The boot lid lock cover really isn't easy to remove and if you use a screwdriver with too wide a blade it will make it almost impossible to remove as the bent sides will act as a lock. In the end I could only get mine off with the whole trim cover...as I carefully levered that off it popped the lock cover off with it. The other point not mentioned is when you pull the old led light out the copper spring clip on the central plastic lug will inevitably fall back inside the boot lid..if you don't spend time poking around to find it it will rattle around inside the lid for evermore and drive you mad.
    Ian B June 2021

  • @philzvids3577
    @philzvids3577 3 года назад +2

    Just replaced mine by following your video. Thanks very much - made the job a lot easier.

    • @tedankouil2356
      @tedankouil2356 3 года назад

      Bro from where did u buy yours? E bay?

    • @philzvids3577
      @philzvids3577 3 года назад +1

      @@tedankouil2356 I got it from a seller on Amazon, but I would check Audi and see how much they want.

    • @tedankouil2356
      @tedankouil2356 3 года назад +1

      @@philzvids3577 I bought one tha same and the plugs doesn’t fit..

  • @SSh1nK
    @SSh1nK 5 лет назад +3

    Thanks to you guys I just did mine today and saved myself some money. Cheers 😁

  • @raymondrocan8912
    @raymondrocan8912 5 месяцев назад +1

    Very useful; thank you very much. Couldn't have done it without it.

  • @Dpo2203
    @Dpo2203 Год назад +2

    Plastic set of trim tools and you won’t mark the panel , or just use some cloth or cardboard , or my close to hand duck tape 👍
    Great video really helpful.
    Thank you 🙏

  • @angiet678
    @angiet678 2 месяца назад +1

    Thank you for the fab video, I have just replaced mine and your instructions made it so easy 👍

  • @matthewlewington2722
    @matthewlewington2722 3 года назад +1

    Great advice some one with absolutely no skills whatsoever like myself was able to do this in like 15mins! 👍🏻

  • @JWL-UK
    @JWL-UK 4 года назад +1

    Been looking for videos to help me remove the trim so I can get get that massive Robin screw that fell off the centre light. It is banging around and driving me nuts! Thanks!

  • @KarlGonzales1
    @KarlGonzales1 Год назад +1

    Nice one and worked for me. Worth checking tips from others too!

  • @JewelsByJase
    @JewelsByJase 4 года назад

    SOOO COOL!!! Thanks, King!!! Needed this How-To!!! MUCH LOVE!!!

  • @Scatterurremanez
    @Scatterurremanez 4 месяца назад +1

    Excellent vid 👌

  • @sergiygeo.7035
    @sergiygeo.7035 7 месяцев назад +1

    Great helpful video! Many thanks!!! 👍🙏🤝

  • @seanfitz575
    @seanfitz575 Год назад +1

    Thanks very much. Great video and easy to follow so successfully changed my light 👍🏼

  • @mikeberry304
    @mikeberry304 2 года назад +1

    Did you connect the boot light wire back up , saw it hanging down before you put the panel on

    • @GarageTechAutomotive
      @GarageTechAutomotive  2 года назад +1

      Hey, there wasn’t a boot light on this part of trim, from memory I think that wire was for the electric spoiler that was originally there. 👍🏼

  • @petera6121
    @petera6121 3 года назад +1

    Great video! Thanks.

  • @peterwebster3558
    @peterwebster3558 4 года назад

    Perfect set of instructions, thanks very much 👍

  • @jabarikellam
    @jabarikellam 10 месяцев назад

    Thanks saved me a trip to the dealer

  • @PeteLeaney
    @PeteLeaney 5 месяцев назад +1

    Great video, but snipe nosed pliers get the clips out … And when you put the clips back in the trim put some tiger seal on them so they don’t slip out…. Trust me one doesn’t go on and pops off drives you mad hearing it rattling about in the boot skin. Overall a simple job . And satisfying not getting that annoying “center light fault” pop up every time you drive a couple of leds out..

  • @feedrate1
    @feedrate1 3 года назад +1

    This helped. Sooo much thank you ☺️

  • @palka7799
    @palka7799 2 года назад +2

    Nice tt👍

  • @rokaexplorer2140
    @rokaexplorer2140 3 года назад

    Buen video visual, llevaba un rato intentandolo y no sabia que estaba pegado, he quitado los tornillos y no salia.

  • @Mani_spielt
    @Mani_spielt Год назад +1

    where did u get this tool from to remove the centre brake light ?

    • @GarageTechAutomotive
      @GarageTechAutomotive  Год назад

      Hey, they were from SnapOn but you can get similar ones from Amazon etc. just search for trim removal tools 👍🏼

  • @ellr4650
    @ellr4650 Год назад +1

    hi...is this centre light the exact same for a roadster ?

    • @GarageTechAutomotive
      @GarageTechAutomotive  Год назад

      Hey, I’m sure it will be slightly different as you have a smaller boot lid, but the general procedure will be the same

  • @grahamdye3725
    @grahamdye3725 Год назад

    Lock cover almost certainly doesn’t need to be removed from the tailgate lining as it will simply come off together with the lining still attached.

  • @K33EEE
    @K33EEE 2 года назад +1

    Did you fit the spoiler?

    • @GarageTechAutomotive
      @GarageTechAutomotive  2 года назад

      hey , yes some time ago now though, didn't record that one unfortunately

    • @K33EEE
      @K33EEE 2 года назад +1

      @@GarageTechAutomotive did you drill it onto the original spoiler to fit ?

    • @GarageTechAutomotive
      @GarageTechAutomotive  2 года назад

      @@K33EEE no, I removed the original spoiler with the motors and the fixed spoiler had studs that fitted into the same holes as the original one. Just bolted it up

  • @janbiakowski6527
    @janbiakowski6527 5 лет назад +1

    Thank you very much!!! :D

  • @arseniofrontela5829
    @arseniofrontela5829 5 лет назад

    Great information thank you for sharing.

  • @antonanderson2901
    @antonanderson2901 4 года назад

    Fantastico grazie. Franz

  • @MrStecol
    @MrStecol 4 года назад

    Hi can you say where you got the replacement light from and the part number please.

  • @Dario-bl1ww
    @Dario-bl1ww 5 лет назад

    Hi you helped me on my audi t t mk1 alternator lead and crank sfaft sensor..... Would u ever do a petrol pump and sender unit under back seat having major issues.... Thanks dario.... Voltage thing ur ids still there and u done my oil pipe threw ur vids merci buddy

    • @GarageTechAutomotive
      @GarageTechAutomotive  5 лет назад

      Hey Dario, I don’t have a TT anymore to make a video unfortunately. What’s the issue???

  • @vincevince309
    @vincevince309 4 года назад

    thanks guy!

  • @sarahrozzier
    @sarahrozzier 2 года назад

    I cannot get the boot lock cover off at all I’ve tried everything

  • @PedroFriasXO
    @PedroFriasXO 4 года назад +2

    I bought a new one and followed ur instructions and mine won’t turn on I wonder if it’s something bad

    • @MrMotorNerd
      @MrMotorNerd 4 года назад

      They have earthing issues on the rear , check power at led to negative terminal of battery with multimeter If 12 volts its the earth wire , probably at earting point on module J519 under steering wheel

  • @rowenramnath2016
    @rowenramnath2016 Год назад +1

    I wish I can replace my

  • @tdasch2901
    @tdasch2901 4 года назад +4

    Oh for Pepe sakes 😆. Invest in some plastic trim removal tools. 5$

  • @Bigwillproductions
    @Bigwillproductions 2 года назад

    What’s the part number ?

  • @__joris
    @__joris 4 года назад +2

    Few things;
    Flatbed screwdriver for trim removal is not recommended, you will scratch the plastics!
    Never leave something hanging to a wire, you might break it (tear inside) and you’ll have a bad time. Don’t be lazy and remove it properly.
    Hard plastics do hurt your paintwork. Mask it off if you care about your paint!

  • @Peter-it4wm
    @Peter-it4wm 9 месяцев назад

    Dont buy cheap parts from China..they dont last...buy audi on this light..i learnt the hard way..oh and use plastic tools...

  • @Carl-yx1ww
    @Carl-yx1ww Месяц назад +1

    Lol