I discovered how - it’s actual a metal tip for that third screw. You need to tap it lightly with a hammer to and the ‘metal screw’ will push out the tail light. Not with too much power otherwise the tail light will fall to the ground. It’s rather simple.
@@vtscrogers Dude. I pulled on this piece of plastic with a pair of pliers for 30 min, cause that's what the guy in the video said to do. Then finally I decided to read the comments Thanks. I would have never figured it out.
@@allautoneed378 I found how some guy cut it apparently you don't cut the rubber you get a hammer and hammer it out but make sure everything is attached or it will fly out
You have to talk louder papa
Just watch the damn video and appreciate he's showing how it's done🙄🙄
El junior your life must be really corny if u get butt hurt over something like this 😂 😂 que pendejo tu eres 💀
@@kinggucci6742 neta que si 😂😂
@@california_gold sorry my voice was to low.
How do you get that piece of plastic off?
I discovered how - it’s actual a metal tip for that third screw. You need to tap it lightly with a hammer to and the ‘metal screw’ will push out the tail light. Not with too much power otherwise the tail light will fall to the ground. It’s rather simple.
@@vtscrogers
Dude. I pulled on this piece of plastic with a pair of pliers for 30 min, cause that's what the guy in the video said to do.
Then finally I decided to read the comments
Thanks. I would have never figured it out.
I am so glad you asked.
Haha I know! It took me forever to figure it out. I’m actually angry with this video because the guy literally says nothing about it.
@@vtscrogers sorry for than i was so busy that day
Sounds like you have noise canceling on bro
im working in shop in busy one
Why do you remove the whole light fixture instead of just removing the bulb from inside the trunk?
just is someone he need to remove the all light for replacement so i do replace the bulb and the light assembly in one video
PLEASE SPEAK UP BRO!!!!
next time man
How do you remove the rubber piece
with one the inside cover or the light ?
@@allautoneed378 I found how some guy cut it apparently you don't cut the rubber you get a hammer and hammer it out but make sure everything is attached or it will fly out
Thank you for the tip. It did the trick.
you very welcome
Thank you
any time
Thx!