Cub 106 Kohler command swap

[@iibc2997]

Thank you very much for this video! I had no idea how the wiring worked and you laid it out in 6 easy steps thanks you!

[@edwardellis1404]

vDuz Ftw I am glad that it helped you out good luck with your project

[@GarrettBoddie90]

So I just picked up a cub 128 and I've got a kholer ch940 34 horse I'm trying to figure out if all the flywheel adapters are the same for all the command series or if they're only good up to the 24 horse

[@stuszith]

Wow!!! Was the old engine a Kohler K -series and does the Zach Kerber Machine &Design machine Adaptors for a Model 72 Narrow frame????

[@521farmer]

Ya doin fine work easy to Understand and do thks for sharin this ya Got my Sub Question ya got in back ground a Desoto what Yr is she Mine is 50 Desoto re doin mine wondering if ya Had a Book or any ideas on wiring here bk up cause mine got burnt by Friend that put 12 volt in stead of 6 volt Oppss So anything wood help Me Farmer keep goin lookin great Hope to hear from ya been lookin over 3 yrs for anything

[@clintard]

Will you please show a properly updated clutch setup for these? Im not making a puller but id like to do this swap and have a strong driveline. Thank u sir!

[@chuckfowler4754]

I’d like to know too

[@qgood1234]

Did you use the stock mounting holes??

[@jhitt79]

Is the kohler command better or worse than a magnum 20?

[@edwardellis1404]

I personally prefer the commands over the magnums.

[@loranmccrimmon2451]

Were did u get that adapter for the flywheel

[@edwardellis1404]

Loran Mccrimmon Zach Kerber Machine & Design

[@loranmccrimmon2451]

Edward Ellis thanks for the reply. Do they make an adapter for the brigs vanguard

[@trailerparkgarage6574]

Can you make a detailed video on how the drive system works?

[@edwardellis1404]

legotec49 what exactly is it that you need to see?

[@trailerparkgarage6574]

Edward Ellis how the trans is connected to the engine, and clutch

[@jhitt79]

@@trailerparkgarage6574 by a drive shaft.