FLSun S1 - It's Fast Until it Just Shuts Off
HTML-код
- Опубликовано: 3 окт 2024
- Not sure what's going on here. The console says "Loaded gcode offsets from saved variables [{'x': None, 'y'; None, 'z': '0.02'}] right at the moment of failure. This is gcode I sliced myself because I wanted to test the machine with ASA, but I also had the same issue with PLA using the pre-loaded benchy gcode. The screen says "Printing abnormally interrupted." Has anyone else seen an error like this? I plan to do a full review of this machine, but only after I have it running.
Why do i need extreme high speeds if it can't work properly?
I got the same thing, random stop printing, layer shifting, on FLSUN SR (support could only advise tightening the belts, and reflash firmware) until I reduced the motors current and print speed to 60mm sec.
any way, this machine is very impressive.
Oh boy - wait 'til I tell you what the problem was. Just figured it out. Will post a follow-up video explaining. It's not great.
@@MaximalistWorkshopwhat was the problem? I am having a similar issue. It randomly blinks the lights and appears to crash. Even mid-calibration.
@@MaximalistWorkshopplease tell us
I have same issue