hi sir great video! this is a nice engine but is it still possible to upgrade to high lift camshafts and a bigger throttle body? probably have it custom built kung wala po ano?
this brand new engine really cheap, 6 times cheaper then 4G63, i think can stroke to 4G64... pretty much same i think -:expender can run with 40mm piston , ofcuz Proton Waja Boss can run with 50mm.... already overpowered, the bolt on twin turbo fiat abarart turbo.....for 30 degree angle chop 🪓 turbo turbine shell, then follow the design of 2 stroke exhaust stomach.... melting cast to follow the shape then welding using TIG...why?...why we do that?.....cause turbo not blow up to pieces, the air just pull back is boost too high....run using Adobe Flow if you not believe what I'm said
Nice video for my xpander . I already have idea on how to change the timing chain.😂
Děkuji velice skvělé video 🙂
Why you need to rebuild? Is it a good strong design or have some weak point in your opinion?
Какое масло лучше лить в этот мотор?
Have video for 3a92?
Does F5MGB fit that engine ?
What spark plugs did you but on?
dude my kind of video...subscribed....
Seriously tho, both the engine build and video....high quality work....
Thank you! :)
Is this a 4A92 Mitsubishi engine? i need some information about it's reliability.
Bad engine
@@thefatimasecret3034 for what reasons ?
how to put timing fb25
Where is this?
hi sir great video! this is a nice engine but is it still possible to upgrade to high lift camshafts and a bigger throttle body? probably have it custom built kung wala po ano?
Can anyone help me find that piston ring ?
Where to fit Steering motor?
it uses an electric power steering i guess
Xpander engine
👍👍👍
😮
this brand new engine really cheap, 6 times cheaper then 4G63, i think can stroke to 4G64... pretty much same i think
-:expender can run with 40mm piston , ofcuz Proton Waja Boss can run with 50mm.... already overpowered, the bolt on twin turbo fiat abarart turbo.....for 30 degree angle chop 🪓 turbo turbine shell, then follow the design of 2 stroke exhaust stomach.... melting cast to follow the shape then welding using TIG...why?...why we do that?.....cause turbo not blow up to pieces, the air just pull back is boost too high....run using Adobe Flow if you not believe what I'm said
Silnik