Voron 2.4 R2 mods and upgrades ... vanilla to a BEAST! part 1

sponsor:
//Check out PCBWay, the one-stop solution for PCB manufacturing and assembly, 3D printing, CNC and more! Explore their open source community www.pcbway.com/
We got ourselfs a second hand Voron 2.4 R2 can we upgrade it from Vanilla to a BEAST?

[@Retro_D]

looks great, nice job

[@TheMugwump1]

My voron has been printing for like 5 months with zero issues. Once you get it dialed in it just works.
If you print ABS or ASA don't bother with the nevermore unless you're gonna make the big one that sits on top or the rear. That tiny one that goes under the bed is pretty much only good for moving the air around to heat the chamber. There's simply not enough volume of carbon to do any meaningful filtering. That room still stinks to high hell if I don't have the exhaust fan on.
The 350 is just a tad too large for me also. I'm 6'3" and I can just barely get a hold of it. I had to get a cart to move it to its permanent place because it's just so cumbersome to move and I would never risk dropping it. I would get the 300 or maybe even the 250 for my next one.
Run the input shaper once using Klippain Shake N tune. Theres a github and also some videos here on youtube. Its really easy and you can just avoid the speeds that make all the noises.
The lights are def a must for the chamber. Don't forget the leds for the stealthburner.

[@aim6mac]

thank you for your time, awesome suggestions!

[@bezzeh]

Id like to give a shout out for the bltouch, the can bus adxl doesnt give you the values you need since it sits on top with its adapter.
I have one but i need to finetune it with a separate adxl

[@SteinerSE]

Clicky rather than Tap?

[@oscarvogel2140]

Rama idlers and nevermore?

[@aim6mac]

noted!