VW MK4 Bora/Jetta VR6 Project EP6 - Clutch Kit/Gearbox Install + FIRST START!!
HTML-код
- Опубликовано: 8 сен 2024
- I continue with the reassembling process but this time it's the clutch and gearbox!
I installed an ACS Dual Mass Clutch Kit with all new hardware and fresh fluids!
Finally get it back together enough to give it a first start but it didn't go to plan!
Will it run? You'll have to watch to find. out!
Thanks for watching and hope you enjoy!
LIKE 👍
SUBSCRIBE ✍
SHARE 🤙
Follow me on:
Instagram: @ap__builds
-----------------------------------------
Facebook: AP.builds01
-----------------------------------------
Check out my other videos!
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Music from freetousemusic...
Eric Lund, Everyday
• 🤷 Vlog No Copyright Ch...
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Track: Disfigure - Blank [NCS Release]
Music provided by NoCopyrightSounds.
Watch: • Disfigure - Blank | Me...
Free Download / Stream: ncs.io/Blank
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
What type of transmission did you use?
@jordanjones6071 the transmission is a 02M 6spd
Will the VR6 manual transmission fit on the V5 Engine?
Technically yes, being the V5 box has the same bell housing as the V6 box but I'd say the gear ratios will be different and possibly the driveshaft cups could be different as I've never personally checked both.
@@apbuilds1519 okay sir thanks but would really like to know cause I want to move from automatic to manual.
@ru-jeanizaaks1290 if you're going from Auto to manual, then definitely get yourself some new driveshafts to match the gearbox 👍 then you'll be golden
@@apbuilds1519 indeed I will get the hole kit.🤙🫡
By the way I like your work.🤙
What are you using to hold the flywheel as you torque?
My partner holding a breaker bar on the crank 😅
Its the same engine with mk5 1.6?
This engine is a 2.8 VR6
That short pipe coming off the SAI with the big filter on it. Is it supposed to go anywhere or just to atmosphere? Also is it supposed to be loose on the inside?
I'm getting a code for incorrect flow and struggling to find the issue.
It seems to just hang there. It has a filter in the end. From the pictures I've seen online it has a ball inside. Maybe try taking yours apart? The filters can be replaced too if need be.
@@apbuilds1519 appreciate it mate, by any chance you have a part number for that pipe? If it's easier I may buy a replacement.
Hello mate is this 4motion?
Hey mate, sure is!
@@apbuilds1519
Thanks for the reply. I'm a bit stuck I am about to do my V5 it has a 10 bolt vr6 crank flywheel but I've bought a 228mm clutch kit with a 6 bolt flywheel.
Do you know if I get a vr6 flywheel for an old corrado will it work with my 228mm clutch?
It's for a 5 speed 02j gearbox
@garvey2510 I used a vr6 clutch kit on my 1.8T which also runs 02J gearbox