LDS 465 1A Running in M35A2

Поделиться
HTML-код
  • Опубликовано: 4 окт 2024
  • NEW LDS-465-1A Running in M35A2

Комментарии • 17

  • @deplorableconstitutionalis2834
    @deplorableconstitutionalis2834 9 месяцев назад +1

    Sounds phenomenal imo

  • @nighthawkrandy
    @nighthawkrandy 2 года назад +3

    If you put on spin on oil filters your oil pressure will come up much quicker. Thanks for posting

    • @brianp454
      @brianp454  2 года назад +3

      Yes, I have YATonka pin on filters on the LDT engine I took out. I'll swap them over after I do a break in on this new engine. It has all new filters, so might as well use them for a bit.

  • @depede384
    @depede384 2 года назад +1

    nice m35a2. it's to my truck.

  • @tikiman48
    @tikiman48 2 года назад +1

    Runs good. Trying to get one running right now, it doesn’t want to start, starting to think the hydraulic head is bad.

    • @brianp454
      @brianp454  2 года назад +1

      Good luck! Let me know if you have a question

    • @tikiman48
      @tikiman48 2 года назад

      @@brianp454 hey I do have some questions
      This truck hardly has any low side fuel pressure from the lift pump. Would this cause it to not start? Also, when I crack the injector lines, I only get pressurized fuel from 2 of them. Is it possible the hydraulic head is bad? I know this truck ran 3 years ago, so I’m not sure if the hydraulic head could’ve failed from sitting. Is it also worth checking injectors?

    • @brianp454
      @brianp454  2 года назад

      @@tikiman48 I'd make sure air is purged 1st

  • @hummerguy
    @hummerguy Год назад

    Is the power noticeably different from the LDT?

  • @otisarmyalso
    @otisarmyalso 2 года назад

    What the difference in LDT v LDS? Nice mods on steering

    • @brianp454
      @brianp454  2 года назад +2

      there's a thread on Steel Soldiers on the subject. Short version: More power with lower EGT's, different pistons, rocker arms, etc.

    • @pendulum4734
      @pendulum4734 2 года назад +1

      Can you go into more detail on the steering wheel? I’d like to do the same on mine.

    • @otisarmyalso
      @otisarmyalso 2 года назад

      @@brianp454 thanks will look up the thread, btw on power assist steering … did you consider a vac assist?

    • @brianp454
      @brianp454  2 года назад

      @@pendulum4734 ‎60409022-BLK

    • @brianp454
      @brianp454  2 года назад +1

      @@otisarmyalso I considered the air setup, but it's just not as good a setup.