Cr125 Exhaust valve/governor

[@Zackrey507mx]

thank you for your content, youtube needs more of your knowledge, cant find manuals anymore, and people like you save my day.

[@johnclark3431]

Thank you greatly for this video, I'm up late 3am trying to figure out how the linkage is suppose to be timed when the governor is installed....great help, thank you again!

[@mrw1054]

Thank you Sir! 100 percent helpful and this just saved my FRIDAY night! 99CR125

[@Junior-fd8ux]

You can use a little bit of Vaseline to hold the governor in if its really fighting you. Good video

[@Zackrey507mx]

i prefer ky jelly

[@scott2495]

This is just what i needed. Thanks

[@jhonsonvegasserrano7836]

Hola amigo saludos desde venezuela quisiera preguntarte como comprar un cilindro y culata porque tengo un Cr 125 de 1999 y poder hacer un envió hasta aquí hasta venezuela

[@isaacrangel3686]

Hey what year engine is that

[@Foryourinfo369]

Ok now I get it! Thank you!

[@richardstremlow6075]

I am building the same bike. You made it look easy. Thanks

[@jenniferbradshaw298]

im doing a 94 cr125r.this will be helpful

[@thomashayward94]

I’m doing the exact same job on my 99 cr 125

[@alunn4871]

@@thomashayward94 I’m rebuilding my 99 125 any tips when I tried putting the power valves back one looked like it was pushing into the cylinder and scratching the piston do you think it needs replaced or it’s just not set right I don’t know much about rebuilding

[@thomashayward94]

Hey mate, what torque specs do you tighten these bolts down to please?

[@aknewell1987]

It’s 7ft pounds according to my manual. It is stated it the video. If your referring to the exhaust valve allen screws I didn’t find a torque spec for them so I used my best judgment when tightening them down

[@PTI_KEFRAN]

👍🤩🤩🤩🤩👌🇫🇷