Is there a minimum distance for bends to be away from the fittings that you'd recommend? For example coming off manifold to a bulkhead to pass through the false floor. Is there a minimum length for the 90 degree bend to be (aside from the benders capability) or is that not an issue? I currently have a few of mine at 2.5" 90s and I'm wondering if the bend itself is to close to the fitting; maybe I should extend the piece that is actually going into the fitting or leaving the manifold. So instead of a "stub" 2.5" 90, mark it xyz distance from the end to give myself a straighter section to put into the fittings. All PTC bulkhead fittings so that's why I'm wondering, not secure like the compression ones.
Each fitting is different. Take some tube and experiment with distances and clearance. I stick to similar fittings so all my templates apply. If there is a major change i make new templates.
Can a 1/4 hardline fit to a push to connect fitting? Where do u buy dot approved hardliners? Can ss hardline fit my setup? I only need less than 3 feet I will mount on my setup to top of my trunk board.
Good Stuff! Subbed,👍👍👍
Thanks for the sub!
Is there a minimum distance for bends to be away from the fittings that you'd recommend? For example coming off manifold to a bulkhead to pass through the false floor. Is there a minimum length for the 90 degree bend to be (aside from the benders capability) or is that not an issue? I currently have a few of mine at 2.5" 90s and I'm wondering if the bend itself is to close to the fitting; maybe I should extend the piece that is actually going into the fitting or leaving the manifold. So instead of a "stub" 2.5" 90, mark it xyz distance from the end to give myself a straighter section to put into the fittings. All PTC bulkhead fittings so that's why I'm wondering, not secure like the compression ones.
Each fitting is different. Take some tube and experiment with distances and clearance. I stick to similar fittings so all my templates apply. If there is a major change i make new templates.
Is it possible to plum your airlines using steel brake line and brake line tube fittings?
Question, could you run regular 1/4 inch airline hose instead of hardline?
You can run anything you wish. Many people employ hardline as a beauty setup and to make trunks look nice.
Where did u get your hard lines from?
Follow my other videos. You will know. :)
Any link or website to order dot compression fittings ?
Google is your friend :)
@@squeakycleanair cant find everrything and i want to make shure is the right thing is it specific to hard line?
Parker or swaglok are good
What fittings do you use to connect the 1/4" hose to the hardline? Compression?
Ptc, its all mentioned in video.
@@squeakycleanair sorry I missed that part lol thank you!
@@JA-sj3mb sweet. Holler if you got any more questions :)
Can a 1/4 hardline fit to a push to connect fitting? Where do u buy dot approved hardliners? Can ss hardline fit my setup? I only need less than 3 feet I will mount on my setup to top of my trunk board.