I would really like to see videos where you change parameters and use TCP. I don't know enough in this area. I use 3D assist but I am sure I could be much better doing it. I have a part where my chamfer mill take a heavy beating if I could change the depth so I don't use the same part of the cutting edge all the time then I could use it longer time. I tried to change in the TCP but didn't know how to do it. @@TheHEHGroup
Really well done. Thank you for this great review.
Thank you!! Great videos, watched all of them! So happy to find good info available.
Glad it was helpful!
Thank you for videos, I watch them again and again clear informations explaining
Glad you like them!
Thx for your videos. Would it be possibel to some more videos on milling with Mazatrol
Yes! Do you have any specific requests? Thanks for watching.
I would really like to see videos where you change parameters and use TCP. I don't know enough in this area. I use 3D assist but I am sure I could be much better doing it.
I have a part where my chamfer mill take a heavy beating if I could change the depth so I don't use the same part of the cutting edge all the time then I could use it longer time. I tried to change in the TCP but didn't know how to do it.
@@TheHEHGroup