e46 Shaved Fenders for Tight Fitment!!!

In this video i show you shaving my inner rear fenders to get that really close tight fitment. Nobody wants wack fitment!! Let me know if you have any questions and or enjoyed this video, thank you for watching, make sure to hit that subscribe button and like this video!!!!
17x8 with a 15mm spacer to achieve this fitment, tire size is 205/40/17

[@Elnegg13]

Thank you for the video, this goin to help a lot

[@efoff652]

You can use a heat gun to heat the sealant up and itll all come out almost in one piece, then you dont need to even cut you can just roll them out, just saying

[@prpz5433]

Hey what “epoxy” did you use to seal the two pieces of metal and how has it held up? Any rust?

[@FawtySix]

keep up the grind homie ima do the same here

[@ythniafps4856]

why not bend it in with channel locks and use a ball peen to smooth? i feel like cutting them creates sharp edges and if ur wheel bottoms out on the cut edge it can damage the tire

[@Tony-tk4ht]

do reduce wheel travel you put more preload on the coilover?

[@stocke46]

yea. preload is just spring "pre-compression"

[@StarrVT]

What wheels are those?? I have the same ones and I don’t know what they are.

[@0302ian]

bbs740/741 i think i also have those

[@LevanShow]

Im not going slammed you think its possible to run a wider tire for the rear?

[@KyRoD_]

probably, you might have to roll fenders or trim the liner though

[@kolevera212]

ik this is late but im running 255s 35s in the rear and on coils and i have no rubbing issues

[@is2fiftyslowfsport744]

Why not go to the bodyshop and pull out the fenders?!

[@whotfislvk]

double layered fender pulling it wont do much you need to cut it thin then weld it together

[@is2fiftyslowfsport744]

@@whotfislvk I've pulled my fenders at the bosdyshop before and it made a huge difference on my 3 series

[@whotfislvk]

@@is2fiftyslowfsport744 was it an e46? im not saying you cant do it its just much easier to trim the unnecessary amount of lip the fender has weld it and then roll/pull them. not cutting it you can have an issue messing up the bodylines if youre not careful

[@is2fiftyslowfsport744]

@@whotfislvk yeah it was a E46, bodyshop did an amazing job too, no flat spots

[@whotfislvk]

@@is2fiftyslowfsport744 oh you took it to a shop then yea it was prolly done right but for diy and being cost effective cutting it and welding it is the way to go

[@harisansari6126]

Use a 2x4 peice of wood and you will never have that issue

[@andxrewws]

Old ahh vid