Honestly sounds perfect, I would’ve thought it would’ve had a lot more chop and be a bit louder, very quiet for a cam and straight pipe not obnoxious at all
Where did you get your truck turned after the cam and what all did you replace when you did the cam job I’m looking at doing one and would much appreciate the help.
I had it tuned by mail order tuner. Go on the website and you can type in literally everything you did then you ship your computer to them and they ship it back only takes a couple days. And I replaced the cam, oil pump, timing chain, lifters, pushrods and every single gasket and sensor on the motor. Oil pan and rear main included because everything was leaking
I have an 05 with dual cat into a 3’ inlet Flowmaster super 50 with dual 2 1/2’ outlet going out to 3’ exhaust tips for a deep aggressive growl no drone no clap full stock
Mufflers get rid of the clap noise. If you want it loud without clapping, cut the cats off and run a single Flowmaster or aggressive style muffler. Problem solved. No clapping.
Straight pipes will always clap. I have long tubes, and 2 1/4 duals all the way into 2 cherry bomb extremes on my cammed 76 squarebody It claps insanely loud at 2400 rpm
They’re just 4 pods from Amazon I don’t remember the brand, and then I think I got the bracket on Etsy honestly? It’s metal and really nice. Also buy a cheap 9006 wiring extension and you can cut one end off and wire it to the pods then just plug it into your factory fog light wiring
Sounds to rattlely like you've got glasspacks, get rid of the old cats, with either new hiflow units or none at all and put some classic Flowmaster 40s or Magnaflows in and it will sound like a legit muscle car with a lopey cam.
@@fish_R_stinky69 No it sounds bad because it is bad, are you not familiar with exhaust pulsing and the scavenging positive effects from exhaust thermodynamics? Even a rookie would know true duals almost always sound terrible without balancing or the effects of canceling each other engine banks resonance....etc.etc.
@@harleystillwell7519 what kind of mpg do you get? Is it still good enough for a daily driver i have the same exhaust and same truck but i dont want to not be able to drive it like normal when i cam it
I ask doing something as well 08 lt chevy silverado 5.3 lifter 1 finally collapsed so doing up grade so looking for cam now what I can get without tune and what will need to be turned want the chop sound, help if you point me In right direction, Thanks
No matter what you do it’ll have to be tuned sadly. But I had mine tuned from a website called mail order tuner. I mailed it to him and said what I did and he sent it back tuned. Only about $300.
@@harleystillwell7519x pipe and he's right spend the 299 get the speed engineering long tubes it will make it sound more Camaro trans am ish than squat truck
Nope factory converter. I went with this cam because they advertise that it’s factory converter friendly and just last year I had the trans built to a 4L65 and didn’t want to replace my brand new converter
Do a x pipe. It's still gonna be clap trap unless you do like slp quad tips for a ws6 or get the square tip borlas with circle pipe inside. They will be in alot of trans am videos tips and size and shape of the tips make a huge difference
Black widow hour glass internal design no drone thick stainless neighbor hater is the loudest no hour glass design next loudest is neighbor hater this model has the hour glass design and has duel in and duel out
I have a 06 cammed with longtubes, x pipe and 2 spin tech mufflers and it sounds amazing, Pretty loud cold start but driving it sounds so amy
Honestly sounds perfect, I would’ve thought it would’ve had a lot more chop and be a bit louder, very quiet for a cam and straight pipe not obnoxious at all
I have same setup but 4 door crew cab and a lq9 6.0 and same cam new cam def made mine louder
My 5.3 has 40 series Flowmasters it'd slightly modified and sounds amazing
Man, that sounds mean! I love it! Making me wanna cam the bronco
Chopacabra is like a stage 1.25 if there was such a thing which is perfect for trucks.
Add and X crossover, and a couple of Dynomax race bullets. It will still be loud, but have a much cleaner sound.
That’s my plan👍🏻
2-1 Y pipe for +HP , to 3" for flow to FM super 10 or super 40/44 3" in 3" out if you dont want the droan🤙
Where did you get your truck turned after the cam and what all did you replace when you did the cam job I’m looking at doing one and would much appreciate the help.
I had it tuned by mail order tuner. Go on the website and you can type in literally everything you did then you ship your computer to them and they ship it back only takes a couple days. And I replaced the cam, oil pump, timing chain, lifters, pushrods and every single gasket and sensor on the motor. Oil pan and rear main included because everything was leaking
I have an 05 with dual cat into a 3’ inlet Flowmaster super 50 with dual 2 1/2’ outlet going out to 3’ exhaust tips for a deep aggressive growl no drone no clap full stock
Lol, I deleted my Flowmasters and got less drone.
Long tube headers will take the clap out
Agreed 👍 I have the speed engineering longtubes on my 00 gmc sierra and the clap is gone completely.Just alittle raspy
Mufflers get rid of the clap noise. If you want it loud without clapping, cut the cats off and run a single Flowmaster or aggressive style muffler. Problem solved. No clapping.
Great to hear. Thank you
Also if you do a x pipe with longtubes you won't have any clap and if you are worried about passing inspections you can do high flow cats.
Straight pipes will always clap. I have long tubes, and 2 1/4 duals all the way into 2 cherry bomb extremes on my cammed 76 squarebody It claps insanely loud at 2400 rpm
take the cats off, put an x pipe and black widows. It sounds like a squatted truck.
Im sure your whole neighborhood loves you fam.
Somehow no one has complained
That is super clean underneath for an Illinois truck
Lots of hours under there with a sander and some paint😆 really excited someone noticed😂
@@harleystillwell7519where I live we just wash the under once a year then every 3 years coat the under with chassis saver paint
Sounds great no need to change it
Agreed.
Can you keep the factory y pipe after the cats? I have cat back from MBRP. it connects to the flange after the y- pipe.
Yep I have the factory Y pipe still it’ll bolt right up like factory to the headers
Just get a duel in duel out muffler it might eliminate the need for an h or x pipe I ended up
You should run a H pipe and two Magnaflows, H pipes help with low end torque
Yep H pipe is the plan!
Hey man what fog lights you running and what brackets you use for them ?
They’re just 4 pods from Amazon I don’t remember the brand, and then I think I got the bracket on Etsy honestly? It’s metal and really nice. Also buy a cheap 9006 wiring extension and you can cut one end off and wire it to the pods then just plug it into your factory fog light wiring
That rEd jeep truck is bad ass!
Thanks! Hopefully on the road soon
X and quality mufflers change that tooted sound.
Both just showed up today👍🏻
@@harleystillwell7519 😭😭
True duals is why it sounds clapped, needs cancelation via xpipe, j pipes, or h pipe
Agreed I'd shift more on the h pipe x if you want just a tad more power
Does it have a pretty good chop even with cats on still?
Yes a lot actually, but before the cam it didn’t chop much except for a certain rpm
Look into equal length exhaust with X pipe and add some mufflers. Otherwise, truck exhaust is going to sound like truck exhaust.
You should upload an exhaust clip
@@oceanwaves83 i suppose i can. You should search Andregarcia5.0. His truck sounds great.
Sounds to rattlely like you've got glasspacks, get rid of the old cats, with either new hiflow units or none at all and put some classic Flowmaster 40s or Magnaflows in and it will sound like a legit muscle car with a lopey cam.
Those tips look tiny look more like 3s
What color blue is this? Do you have the paint code?
I don’t remember the paint code but it’s called Ming blue metallic, almost purple in the sun, its beautiful
Do you have ac issues? I have same set up but long tubes and my ac is cuts out at stop lights etc …
No sir I’ll have to pay closer attention next time but I think it stays pretty much the same temp driving and stopped
@@harleystillwell7519 do you have a stall converter or factory still
@@codycaballero3660 factory
I gotta know, how bad are the MPG's on your rig lol
Smiles per gallon man!😂 just kidding, it’s telling me 13
put some 12-18 in glass packs on er
What rearend is that?
It’s the stock axle with a PPE cover powder coated illusion cherry
what size pipes
2.5”
My 2001 6.0 runs best with an X flow muffler. Ran straight pipes and major loss of torque, and gas milage.
Plus it always sounds terrible unless it's a fuel racing setup that doesn't need exhaust scavenging
Lol, it's just in your head.
@@fish_R_stinky69 No it sounds bad because it is bad, are you not familiar with exhaust pulsing and the scavenging positive effects from exhaust thermodynamics? Even a rookie would know true duals almost always sound terrible without balancing or the effects of canceling each other engine banks resonance....etc.etc.
LOVE LOVE LOVE IT😊
Nice!
Did you have to tune it?
Yes I sent my ecu to mailordertuner.com with the cam specs and they mailed it back all ready to go
@@harleystillwell7519 what kind of mpg do you get? Is it still good enough for a daily driver i have the same exhaust and same truck but i dont want to not be able to drive it like normal when i cam it
Did you have to get it tuned
I ask doing something as well 08 lt chevy silverado 5.3 lifter 1 finally collapsed so doing up grade so looking for cam now what I can get without tune and what will need to be turned want the chop sound, help if you point me In right direction, Thanks
No matter what you do it’ll have to be tuned sadly. But I had mine tuned from a website called mail order tuner. I mailed it to him and said what I did and he sent it back tuned. Only about $300.
@@harleystillwell7519do you have to run a specific type of fuel now?
I like the sound but I would not like it if I had daily drive it
Long tubes with a xpipe
Think I’m gonna do an H pipe and lose the cats
@@harleystillwell7519x pipe and he's right spend the 299 get the speed engineering long tubes it will make it sound more Camaro trans am ish than squat truck
Do you have a stall?
Nope factory converter. I went with this cam because they advertise that it’s factory converter friendly and just last year I had the trans built to a 4L65 and didn’t want to replace my brand new converter
@@harleystillwell7519 since you just did the upgrade not long ago, does the 4l65 have an extra gear over the 60?
@@cw.weldingco.341 no sir it’s just stronger internally. Still a 4 speed
Do a x pipe. It's still gonna be clap trap unless you do like slp quad tips for a ws6 or get the square tip borlas with circle pipe inside. They will be in alot of trans am videos tips and size and shape of the tips make a huge difference
ruclips.net/video/CjE4EEwZUu0/видео.html the quad tips make a big difference
How did you get the factory cats to connect to the shorty headers?
They bolt straight up
I'd put 2 super 10s on it
Needs mufflers. Will actually run better.
It’s got them now👍🏻
Was waiting for redline 😕
Let her get broke in first😂
@@harleystillwell7519 always break it in how ur gonna run it 😆
FACTS
Black widow hour glass internal design no drone thick stainless neighbor hater is the loudest no hour glass design next loudest is neighbor hater this model has the hour glass design and has duel in and duel out
Not too loud.
I guarantee you it’s a lot louder in person
@@chrishansen7004 I have a straight-piped truck IRL.
@@chrishansen7004 I also have a straight-piped Foxbody.
Put in hi flow cats and 2 carven r mufflers. Problem solved
Sounds obnoxious. But to each his own.
I agree! Too obnoxious haha
💀
4:16 EWWWW😨
What
@@harleystillwell7519 What
@@harleystillwell7519 Oh, there's a gurl there : (
Personally ill never understand why people make slow ass trucks/cars super loud, they never sound good 💀 but hey to each his own
It literally has a cam in it
@@ihatecarslmao okay?? Whats thats got to do with anything ? 😂
@@brandonnunez3644 do you understand what a cam does
@@ihatecarslmao yes.. again.. whats that got to do with anything?
Sorry you don’t like it
If there are cats it doest have straights those still muffle