K1600GTL (2016) Heated Gear Install using a HEX ezCAN

Found a solution to adding heated gear to my new (to me) bike. Utilizing the HEX ezCAN to setup two heated ports operating separately, power for my dashcam and garage door opener, and the final port for additional brake lights.
All controlled through the bikes normal controls so it makes a very clean install.
I left all my tripods at the office so sorry for the shake.
Music credits:
Other Scenarios
Blue city lights
Dressed as animals
Go big or go home
Flames
Phantom
Friends

[@jeffshootsstuff]

Pretty slick!

[@whiskey6969g]

That's hot!

[@marlenpadberg]

I take full responsibility for this hooligan riding this bike...

[@smsrobertlumby71]

How in the world did you get a garage door opener on there? I can't figure it out. Help?

[@VulcanRide]

At 4:33 you will see the back of the garage door opener; I just extended the switch by soldering wires to the back of the internal switch and to the external switch. The only hard part is taking apart the garage door opener, I could have located it about anywhere but I also power the opener from the ezCAN so I never have to worry about changing out the expensive 12v battery. Hope that helps.