Any drone? I have one for my truck. No cats with an X pipe and going to have it reversed to single 3 inch out. Body style older than yours though with the 454 vortec.
I didn’t have drone really up until I cut off the axle back and dumped it. Even then it’s not terrible. If you have the piping all the behind the rear wheel I think it’ll be a very minimal amount of drone for you.
@@OronasGarage oh yeah then I should be good. I have a tailpipe that was previous on my truck coming out in the same spot yours was. Eased my mind a bit on doing it haha.
@@dylanrex3441 nice! I’ve always loved those 454’s and the 8.1! Wouldn’t mind have a big block in this heavy girl lol. Hopefully you get a nice deep tone from your exhaust!
@@OronasGarage hoping you’re right about minimal drone had a flow fx by flowmaster. Same dimensions but that sounded like just a glass pack. Drone wasn’t bad though.
Yes it has headers. I run Flowtech shorty headers. Cats have been deleted and it is dual piping into an x pipe then shortly after it is a 2.5” dual inlet Borla with 3” outlet.
@@DRDROP-fj4bo Thanks! I’m thinking of changing it eventually but I want to see what it sounds like with a cam before I change it up. The part number is (40349). It’s a universal muffler from Borla.
Here is the part number, however this part number will require you to bypass the egr that goes to the passenger primary tube. 03-07 do not have this, only the 99-02 have it. I used an egr delete kit from LSX and I ran these headers since they have 1” 3/4 primary tubes. www.jegs.com/i/Flowtech/387/31142/10002/-1
Any drone? I have one for my truck. No cats with an X pipe and going to have it reversed to single 3 inch out. Body style older than yours though with the 454 vortec.
I didn’t have drone really up until I cut off the axle back and dumped it. Even then it’s not terrible. If you have the piping all the behind the rear wheel I think it’ll be a very minimal amount of drone for you.
@@OronasGarage oh yeah then I should be good. I have a tailpipe that was previous on my truck coming out in the same spot yours was. Eased my mind a bit on doing it haha.
@@dylanrex3441 nice! I’ve always loved those 454’s and the 8.1! Wouldn’t mind have a big block in this heavy girl lol. Hopefully you get a nice deep tone from your exhaust!
@@OronasGarage I’ll find out next Friday.
@@OronasGarage hoping you’re right about minimal drone had a flow fx by flowmaster. Same dimensions but that sounded like just a glass pack. Drone wasn’t bad though.
Tell me about your complete exhaust set up. You put headers on didn't you?
Yes it has headers. I run Flowtech shorty headers. Cats have been deleted and it is dual piping into an x pipe then shortly after it is a 2.5” dual inlet Borla with 3” outlet.
@@OronasGarage which borla
Love the sound. Throaty
@@DRDROP-fj4bo Thanks! I’m thinking of changing it eventually but I want to see what it sounds like with a cam before I change it up. The part number is (40349). It’s a universal muffler from Borla.
Do you remember the part number for the headers you have?
Here is the part number, however this part number will require you to bypass the egr that goes to the passenger primary tube. 03-07 do not have this, only the 99-02 have it. I used an egr delete kit from LSX and I ran these headers since they have 1” 3/4 primary tubes.
www.jegs.com/i/Flowtech/387/31142/10002/-1
👍🏽🤙🏽
Need moar cam