Mini Cooper S R56 Turbo Oil Feed Line Replacement
HTML-код
- Опубликовано: 29 янв 2020
- Video presents a method to replace the turbo oil feel line on a 2008 Mini Cooper S with the R56 turbo engine. Also discusses replacing oil seals on the turbo water cooling heat exchanger.
This is job which requires great finger dexterity since space is limited. Some people have pulled the front end off to gain easier access. 
Авто/Мото
Thank you for the video. Very detailed enough that my anxiety over tackling this (prior to my watching this) has been alleviated. Love the part where you say "have to warn you, it's not easy" and "as long as you're patient and take your time, you can do this". Setting reasonable expectations 👍👍
Thanks for the video, made the job much easier. Took me just under three hours.
Doing mine now! I didn't disconnect my o2 sensors. I just removed them from my downpipe and let them hang. Mine is a bit easier because I already had it apart to install my downpipe. The hardest part is the heat shield! Thanks for the video!
Good video, especially doing it without putting in front end service mode. If you are doing the oil filter housing gaskets, I would recommend front end service mode and dump the coolant in the beginning.
One thing I noticed you missed. The heat shield blanket protecting the Turbo Oil feed line. It's a recall that most people have already had done. Usually they come with these stainless steel braided line kits. I would advise everyone to put one on if they don't have it already. It protects that oil feed line from the intense heat of the turbo.
Good advice, thanks !
What’s the recall called?
Great job doing this without putting mini into service position!
Thanks for the video 👍🏼
Do you think or guess if I squirt a bit of RTV silicon or sealant inside just where that tube fits in that crimp where o rings gone it will seal it ? Just a lot of work and mines same spot leak. I actually tapped the tube and it moved in more to fitting
It might help in the short term but long term, It may come back to haunt you
sorry for doing this job is it necessary to change the oil and filter?
My pipe has the same movement but no leak at all?
Hi, question, my mechanic find out a leaking in my turbo oil line, he also told me that it had an "anomally" and the whole turbo needs to be replaced, do you guys think I can solve my problem with this? I found this same kit a cumple of days back, im curious because this seems to be the perfect solution for me ..help :/
Not sure, I know that there is some oil in the intake ducts between the turbo and the throttle body. The duct betweent the turbo and air filter is clean. This leads me to believe that the seals in the turbo are starting to leak. I may replace those next
This hose is Kinuwaga from Amazon?
is it necessary to change the oil housing gasket?
I am assuming you are referring to the oil cooler to block seal. It is not neccesary but since you are in there, the access is great. This is a know leak area so I just replaced it while I was in there
@@vanguardhotrodshop8633 thanks!
I need tork line oil mini cooper
Heat shield bolts😢.
Wasn't making any hissing noises before you took it apart and it wouldn't have helped just to try to tighten it a little bit more
The leak was not at the copper washer, it was the crimp between the hose and the fitting