Great tip. What about using a piece of flat, thicker copper bus bar to extend the bottom, that might allow more support? I think though I have only seen that at certain electrical supply company. Or, if I recall correctly, there are some alternate jaws for the clamp spot welder, that are basically chunks of copper. I am imagining something say 1/2 inch square stock (or 8mm if a metric source is available) again great tip. I have been considering getting one of those, now it's moved up on my wanna have as an option.. purchases... List. Thank you
Great tip. What about using a piece of flat, thicker copper bus bar to extend the bottom, that might allow more support? I think though I have only seen that at certain electrical supply company. Or, if I recall correctly, there are some alternate jaws for the clamp spot welder, that are basically chunks of copper. I am imagining something say 1/2 inch square stock (or 8mm if a metric source is available) again great tip. I have been considering getting one of those, now it's moved up on my wanna have as an option.. purchases... List. Thank you
@@phillkenyon4378
Endless possibilities for improvement. Thanks for the comments!