This is very interesting. I remember being on a grading job as the inspector(1984) where the contractor got a laser system with a regular tripod and a 15-foot high tripod where all of the machines were fitted with receivers so they could all work off the same BM at the same time. The project was about 1500 feet long and 700 feet wide and about 20 feet deep. The system was accurate to 1/16th inch at 1500 feet. The operators weren't happy about using this until they started with about 30 minutes to 1 hour in and they did not want to lose the system. There were also 2 linker rods with it to check grade. Everyone could work at the same time to get the same grade. With the laser line above the machines, no one machine shielded any other machine.
Hopefully sponsoring you! You're the one using this system and showing it in the vids! You should reach out to them, they may send you some goodies to try out like some 3-D GPS stuff!
If the length of the teeth were calculated as part of the benchmark, how can curling flat and pulling back be 12"? Wouldn't one need to use the bucket teeth to check depth again after cleaning out the hole?
Nothing like learning all kinds of things. I think you're doing awesome!
An nice informative explanation of equipment video.
This is very interesting. I remember being on a grading job as the inspector(1984) where the contractor got a laser system with a regular tripod and a 15-foot high tripod where all of the machines were fitted with receivers so they could all work off the same BM at the same time. The project was about 1500 feet long and 700 feet wide and about 20 feet deep. The system was accurate to 1/16th inch at 1500 feet. The operators weren't happy about using this until they started with about 30 minutes to 1 hour in and they did not want to lose the system. There were also 2 linker rods with it to check grade. Everyone could work at the same time to get the same grade. With the laser line above the machines, no one machine shielded any other machine.
I'm thinking Trimble should be sponsoring you in this video! 🤔😃
Absolutely!😅😊
Hopefully sponsoring you! You're the one using this system and showing it in the vids! You should reach out to them, they may send you some goodies to try out like some 3-D GPS stuff!
@@idigit4967 some goodies would be sweet...😃
Can't wait to get mine. Ordered one for each excavator
That is a really nice piece of equipment..It would be a MUST if a Man done this everyday by Himself.! I appreciate the Video 👍🏻
hello ldigt4 its is randy and i like yours video is cool thanks friends randy
Let's gets this baby started
Very cool thanks
If the length of the teeth were calculated as part of the benchmark, how can curling flat and pulling back be 12"? Wouldn't one need to use the bucket teeth to check depth again after cleaning out the hole?
Gday from new Zealand 🇳🇿 hello hello
What’s this system cost? Awesome page by the way
whyd you turn off comments on the mulching video
We just put this system on our new link built 170 and it makes basement digging way better than using a grade man and faster!
🙂💯🖐👌👌👌👌
Just set a 304 up with full automatics, GAMECHANGER! And yes SITECH is correct!
Nice!