05 to 09 Mustang Ignition Switch Replacement (car alarm issues)

In this video, I replace the ignition switch on a 2008 Mustang 4.0. These instructions will work on all 05 to 09 Mustangs. I replaced the ignition switch because the car alarm kept going off and the ECM stated the ignition switch was defective.
Part Used in the Video:
www.autozone.c...

[@rickpowers4356]

Thanks for posting this video. It was very timely for me because my ignition switch started acting up about three weeks ago. I followed your instructions which were very helpful. However, I found my car had the console top sealed down at the factory by melting plastic tabs underneath the door hinge. I was finally able to get to the switch after partially removing the lower dash and also taking out the kick panel and sill plate. Thanks again for your advice. I don’t think I could’ve figured it out on my own.

[@dk8460]

You moving the camera too much…nobody can see what you’re doing

[@johnnyacosta7551]

It would nice if you showed the part and actually placed the camera where we can see what you are doing

[@mustangaddict589]

How can you tell if there bad, swapped engines an now no start at all does nothing when turning key

[@chasingmustangs]

You will get an engine code if bad. If you don't have a reader, I think autozone loans them out. The best place to start is connecting a scanning and reviewing any error codes.

[@mustangaddict589]

@@chasingmustangs interesting Ty for your response after inspecting looks like car is blowing 30 amp fuse soon as I turn the key. It’s for starter also.

[@chasingmustangs]

@mustangaddict589 Check your starter cable. Make sure the nut is not corroded or missing.

[@mustangaddict589]

@@chasingmustangs ok will carry on with it tomorrow

[@truexkev2737]

I like watching your videos very nicely detailed. I am having a issue on my 302 ho when warmed up starts back firing here n there not frequently. Any thoughts ? Appreciate the content you have for us.

[@chasingmustangs]

What year Mustang?

[@truexkev2737]

@@chasingmustangs 94 sn

[@truexkev2737]

@@chasingmustangs recently had it rebuild not sure if mechanic tightened valves so much but I hear a tick as well

[@chasingmustangs]

@truexkev2737 I would take it back to the mechanic. What you are describing could be bad valve seats as well.

[@xGoku4_]

💯

[@Vivianauxito]

Hey,mate. Just reached out to you via email for inquiring an opportunity of Auto LED lighting review. Hope hear from you soon