BMW N47 Balance Shafts Removal and Installation Procedure
HTML-код
- Опубликовано: 28 фев 2024
- How to remove and re-install the Balance shafts / Compensating shafts on BMW N47 diesel engine. In the video we going to replace the balance shafts needle bearings and we going to show how to properly install all the spline gears + the idle gear to the crankshaft, so to avoid any unnecessary vibrations or noises.
First part of the video:
• BMW N47 Timing Chains ...
BMW N47 Balance shafts removal tool:
www.ebay.co.uk/itm/404456879889
BMW N47/N57 front crankshaft installation tool:
www.ebay.co.uk/itm/404456468499
BMW N47 engine stand tool:
www.ebay.co.uk/itm/404282002089
Support the channel : / crankauto
Shop coordinates ( for business inquiries ) : / crankauto
CRANK 
Авто/Мото
It's the bearing that fails in the idler pulley, every single one I've removed is really rough and replacing can make the engine sound a little quieter - easy to find quality bearing from your local supplier press out and press new one in.
Amazing content. Will subscribe!
Really great detailed video, thank you for making. Sadly my N47’s balance shaft bearings have completely failed, new engine ordered :-/. I didn’t know these were an issue otherwise I would have replaced them when I had the engine out for a new chain and seals 30k ago 😭.
All n47 16d doesn't have the balance shaft from factory and runs nice
And one more question i get error low fuel pressure in rail, when i fllor my car at around 4000rpm, i have changed rail,HPFP, valves at them and sensor on rail, and fuel pup in tank, but sill i get same error and car enters limp mode?
Ace ✌️✌️✌️
Very good videos!! I have a bearing defect on my N47D20d from 2012 with 218hp. When I took it apart I noticed that there were no balance shafts installed! Did anyone remove them beforehand or are there engines without balance shafts? Many thanks for an answer. Regards Rolf
try looking in the holes if they are damaged they removed em but they can drive without em its mostly made for comfort
I've seen so called replacement 2.0 engines with no balance shafts, you can simply remove them on the later N47N but the eariler engines they'll remove then turn the bush to block the oil feed at the back of the shaft (e87 N47 engines). It definitely makes the engine shake more without them fitted. The 1.6 engine is only fitted in the 114d & 116d efficient dynamics for example and these have no balance shafts, neither do the 6 cylinders.
👍😎
Do you think it is good idea to remove them, my car does not have them, and it works find no hard vibraitons, nicer sound, btw i bought it this way?
I don't know, I have never tried to assemble it without them. I know Alfa Romeo engines can run without them
@CRANK what's your opinion on deleting balance shafts?
It will be cool experiment but the influence on the timing chains and the bearings will be seen on a long run
@@crank3646 agree with chain part, after all balancer are for smoother running so less vibrations, but imo bearings only suffer from tensinon and torque that it gets from pistons, not so much from given vibrations that could occure with BS delete
I've seen it a few times, engine is quieter but definitely shakes more.
ты русский что ли?