Suppressor for sure and SBR possible depending on how I feel using it with a single point sling up to 100 yards. The problem with SBR’ing it is traveling across state lines and dealing with similar NFA restrictions.
@@bankruptremy4987 not correct. The only type of NFA firearm that cannot be converted to non-NFA status is a machine gun. You can SBR your AR pistol and then later convert it back to a pistol. If the change is going to be permanent, or you are selling it in a non-NFA configuration you should notify ATF to have it removed from the registry.
It’s just a plate, older models had the model name engraved onto it. However these spears are just blank plates.. the virtus model says virtus on the plate, the rattler says rattler on the plate etc.
@@666DemonicEntity I ended up researching behind it earlier today, I guess there is a specific use for it, that plate reinforces the Cam Pin on the inner side of the firearm. It said that area is a high stress area of the weapon. 🫡 you’re welcome.
Awesome , hope it works good for you. I’ve had a blk for years and the 300 blk pmags are the best imo Let us know how she runs if ya don’t mind. The can will be the finishing touch
@@werunguns I do, mine is one of my cheaper builds to start out with but it has always ran 100 percent. The only ammo it never liked were the blunt nose shaped hornady subs. Pistol length gas, 8 inch ballistic advantage barrel. Silencerco harvester which tucks nicely under my rail I run the lancers some too but I just lean towards pmags. Cost less and I just overall like them better. Load easier for sure
@@werunguns I usually run subs, and I liked the hush ammo the best( not sure if their still making it) I bought up a decent amount to have put back. Supers I like the Barnes 110-120 grain copper rounds
Fiochi subs and supers were always great, best bang for the buck if their available is the sellier and bellet. All their ammo is good Seen the subs penetrate level 3 armor. Military arms channel has a great video about those. Shows them going through armor when others wouldn’t. Very cost efficient
@@brannonpardue1358That’s incredible! I saw a deal recently at PSA for AAC ammo in super and sub so decided to try it out. Will try your recommendations next
Due to how old* this comment is, youve probably figured it out by now, but ill leave this here for other people. This specific configuration has a barrel under 16 ibches in length, and as such, if it had a stock, would be considered an SBR- which would subject it to much more strict regulation, and in some states, flat out banned. Due to not having a stock, it can have any length of barrel under 16 inches and be classified as a 'pistol'. Other versions of this gun exist with a stock, either as an SBR (harder to buy) or a regular rifle with a full 16 ibch barrel length. *edit = grammar
@@4bvenom733sorry, but there’s no 300 blk rifle that can chamber a 5.56, the bolt won’t even close. And even if it did, a .223 bullet shot in a .300 barrel wouldn’t even touch the rifling, giving zero stability / precision for the bullet. You can however chamber a .300 blk on a 5.55 by accident and destroy your rifle. If you want an AR or other variant to change from .300BLK to 5.56, you have to change the barrel or the full upper like it was said above (but you can use the same bolt and magazines).
No fucking way would I set foot inside that sub even if it was sitting in my living room and let them bolt us in from the inside. Thank you for showing this but god damn that thing was a death trap. What if one of the monitors decided to smoke out and fill the cabin with smoke or the air delivery system failed and then you’re all piled up on top of each other inside waiting desperately for someone to be able to unbolt the hatch. Something could go wrong before you even left the platform and it would be very challenging for anyone to be able to get that hatch open. Good god it gave me hives just watching it.
@werunguns lol I had somebody flame me on here one day for saying it wrong too haha, I was just messing around but yeah I finally started saying it right. Love the Gun!! I've got an Aimpoint T2, radian charging handle and surefire scout on mine so far
The fab defense point grip with thumb attachment and grovtec single point is feeling amazing
Awesome I’ll check it out!
Well that is one gorgeous gun
What bag was that and how long is the bag? Curious is this will fit well in the Vertx Commuter Sling.
this is the most beautiful thing ive ever laid my eyes on
I love it! Going to release my full review video in about a week
Really trying NOT to add another caliber to my collection but this one is very tempting. Would definitely SBR it.
Suppressor for sure and SBR possible depending on how I feel using it with a single point sling up to 100 yards.
The problem with SBR’ing it is traveling across state lines and dealing with similar NFA restrictions.
I actually felt the same about adding a caliber especially since I already have suppressed 7.62X39, but ultimately this is 2 steps above that.
@@werungunswhen you cross state lines, take the stock off and it reverts back to a pistol.
@@cops312false. Once a firearm is registered as a SBR. It stays a SBR no matter the configuration
@@bankruptremy4987 not correct.
The only type of NFA firearm that cannot be converted to non-NFA status is a machine gun. You can SBR your AR pistol and then later convert it back to a pistol. If the change is going to be permanent, or you are selling it in a non-NFA configuration you should notify ATF to have it removed from the registry.
What backpack are you using?
I want one so bad!
Whats that black piece with the 2 screws on the left hand side of the upper receiver
It’s just a plate, older models had the model name engraved onto it. However these spears are just blank plates.. the virtus model says virtus on the plate, the rattler says rattler on the plate etc.
@ oh ok thanks . I wasnt sure if i had any specific use for it thank you
@@666DemonicEntity I ended up researching behind it earlier today, I guess there is a specific use for it, that plate reinforces the Cam Pin on the inner side of the firearm. It said that area is a high stress area of the weapon. 🫡 you’re welcome.
Nice, I just got the 556 rifle i like it alot! 👍🏼
That’s awesome! I’m considering to get a 16 inch 556 upper to be able to use it as a rifle with a stock. Worth it then?
@@werunguns I'll let you know when I get more rounds through it
Awesome , hope it works good for you. I’ve had a blk for years and the 300 blk pmags are the best imo
Let us know how she runs if ya don’t mind. The can will be the finishing touch
Thanks will do! Do you run a can on yours? What’s your preferred ammo?
@@werunguns I do, mine is one of my cheaper builds to start out with but it has always ran 100 percent. The only ammo it never liked were the blunt nose shaped hornady subs. Pistol length gas, 8 inch ballistic advantage barrel. Silencerco harvester which tucks nicely under my rail
I run the lancers some too but I just lean towards pmags. Cost less and I just overall like them better. Load easier for sure
@@werunguns I usually run subs, and I liked the hush ammo the best( not sure if their still making it) I bought up a decent amount to have put back. Supers I like the Barnes 110-120 grain copper rounds
Fiochi subs and supers were always great, best bang for the buck if their available is the sellier and bellet. All their ammo is good
Seen the subs penetrate level 3 armor. Military arms channel has a great video about those. Shows them going through armor when others wouldn’t. Very cost efficient
@@brannonpardue1358That’s incredible! I saw a deal recently at PSA for AAC ammo in super and sub so decided to try it out. Will try your recommendations next
Whats the cost
Wait so they don’t come with a stock? Sorry I’m kinda new to this
Due to how old* this comment is, youve probably figured it out by now, but ill leave this here for other people.
This specific configuration has a barrel under 16 ibches in length, and as such, if it had a stock, would be considered an SBR- which would subject it to much more strict regulation, and in some states, flat out banned. Due to not having a stock, it can have any length of barrel under 16 inches and be classified as a 'pistol'.
Other versions of this gun exist with a stock, either as an SBR (harder to buy) or a regular rifle with a full 16 ibch barrel length.
*edit = grammar
Does the 300 blk chamber in 556 as well
Need to swap the barrel which should be easy on these
I would just have a 556 upper separately, ready to swap.
Aww that's sucks...I know they make 300 blk out that can chamber in 556. I just don't know if all 300blk can
@@4bvenom733sorry, but there’s no 300 blk rifle that can chamber a 5.56, the bolt won’t even close. And even if it did, a .223 bullet shot in a .300 barrel wouldn’t even touch the rifling, giving zero stability / precision for the bullet.
You can however chamber a .300 blk on a 5.55 by accident and destroy your rifle.
If you want an AR or other variant to change from .300BLK to 5.56, you have to change the barrel or the full upper like it was said above (but you can use the same bolt and magazines).
The thing looks sweet but Jesus 2500$ and that’s how it comes packaged? I really hope the all around quality and performance make up for it
it wont fit in your pack with a suppressor on though
Liked and comment for suggesting GOA.
GOA > NRA
No fucking way would I set foot inside that sub even if it was sitting in my living room and let them bolt us in from the inside. Thank you for showing this but god damn that thing was a death trap. What if one of the monitors decided to smoke out and fill the cabin with smoke or the air delivery system failed and then you’re all piled up on top of each other inside waiting desperately for someone to be able to unbolt the hatch. Something could go wrong before you even left the platform and it would be very challenging for anyone to be able to get that hatch open. Good god it gave me hives just watching it.
That packing is cheap even for Sig Standards, c’mon that’s a 2.5k gun!
Its pronounced ambi-dextrous not ambi-dextrious. Just saying. LOVE the gun, i have the 11.5" model
Thanks for the correction lol. Yeah it’s a great gun
@werunguns lol I had somebody flame me on here one day for saying it wrong too haha, I was just messing around but yeah I finally started saying it right. Love the Gun!! I've got an Aimpoint T2, radian charging handle and surefire scout on mine so far
@@patriotgunner plan to brace or SBR?
@@werunguns I'm gonna sbr it soon for sure because this gun is a keeper
I rather them use cardboard paper than styrofoam.... The balls get in all the mechanics.
Yeah it’s just terrible packaging honestly
2k pistol and shit packaging