Hi I'm new to Plasma and I just received my XR table last month finished setting it up and my first wasn't that bad but ,I would like to know the following configures, what was your Kerf Width ,Feed rate ,Pierce delay, Pierce height ,Plunge rate ,Cut Height and did you use leadin/leadout ?
Is that torch deflector file available somewherr
I just put in a deposit for this same table. I'm just curious what are you using for an air system?
I'm using a 2 stage quincy 60 gal with air dryer
Turned good man.
Thanks
Hi I'm new to Plasma and I just received my XR table last month finished setting it up and my first wasn't that bad but ,I would like to know the following configures, what was your Kerf Width ,Feed rate ,Pierce delay, Pierce height ,Plunge rate ,Cut Height and did you use leadin/leadout ?
Awesome. When can I borrow your machine. This really came out nice.
Just come on over and you can use it. Lol