Sharpening - Proper Magnet Placement
HTML-код
- Опубликовано: 16 сен 2024
- Brandon is going to show you how to properly place your magnets on various blades before you sharpen them.
Enjoy the video! 🎥
If you like these videos visit our RUclips channel for more!
Don't forget to subscribe so you will stay up to date on our future videos and hit the notification button so you never miss out!
As always thank you for supporting our channel. We hope it brings you some value.
The Edge Pro Team.
Follow us on all our channels!
Website: www.theedgepro....
Facebook: / theedgepro
Instagram: / the_edge_pro
Twitter: / the_edge_pro
Excellent vid., on helping a struggling blade sharpener! Because I can’t get these sharp!!! I sharpen knife blades beautifully and many more returning Customers as well as sharpening Scissors.
Again Thank You very Much for your expertise
And I say this, EDGE PRO is the best when it comes to this. I'm from Ghana, West Africa and I follow you a lot.
Keep enlightening us.
Great video thank you for the information.
Very helpful.
Nice one, Brandon!
I was holding the Mag too far back this whole time! Thanks for the Video. Do you have a video about the placement of the comb or cutter on the wheel when grinding in relation to the center line.
You make my business so easy. You have no clue what your doing
Good video. Why do the trimmer blades scoot out from undrtneith the magnet sometimes?
If you are using the rare earth magnets or hard drive magnet they make a single, focused point of contact to the blade versus being spread out to prevent the twist. To prevent that, first I check that I am using light pressure and af it persists I will hold the magnet at the bottom with my thumb and middle finger so that they are touching the blade. usually that stabilizes them enough to not twist.
I ask, can any steel with a very flat surface be used as a rub block please ?
Thanks for your wonderful videos.
What's the name of block you use after sharpening the blade? I mean what kinda material is that?
It's called a rub block! It is made from steel.
Can any steel with a very flat surface be used as a rub block ?
I also want to thank you, I also was holding it wrong,
Which side of the Andis trimmer Comb blade do you sharpen
Hi Zeke! You would sharpen the back side, or flat side of it that the cutters rubs against. Hope that helps!
I hate the red POS magnets. I liked the clips Andis used but Vicsco had the very best. Ace Sharpening in KC MO has great one that is better than Vic's.
Hi , may i know where can i buy the red u shape magnet ? Thank you
Hi! Here is a link to our site where the magnet is listed: www.theedgepro.com/products/small-magnet-r