Was hoping for some lubrication info. There is a grease zerk on the carrier bearing hidden behind the skid plates. Any luck you guys know how much/often it should be greased ?
Yes that’s what the Manuel says. We go by how our machines are driven. If it’s driven slow and on trails then we do it at 500 on first service. If we drive it hard then we do it at 200.
When you measure that much, it fills right to the top. So why measure? Just fill it till it runs out. I don’t mean pours out. When you see it crest the hole stop!
![[#2024MAMA] ROSÉ (로제), Bruno Mars - APT. | Mnet 241122 방송](http://i.ytimg.com/vi/dgGqD28J6aQ/mqdefault.jpg)
Nice video, what stand are you using to keep the UTV in the air?
Great helpful video. Waiting for part 2!
How can I get a pdf of the capacity and torque values you show in the video?
Another helpful video!
Part 2? Anything for trans and coolant change?
Where’s part 2?
Was hoping for some lubrication info. There is a grease zerk on the carrier bearing hidden behind the skid plates. Any luck you guys know how much/often it should be greased ?
2022 uforce 1000 xl
We grease ours with 1 pump every 2 months
How did you remove the fender flares on this on the rear? I have 2023 and the front seem easy, but the rear seem to be connected as a body panel?
The fender flares we have are the CFMoto extended flares. So they clip on. The ones you refer to are the factory molded ones. They don’t come off
My manual says 200 miles for everything fluid on the first service. 200 for oil gear cases transmission coolant etc
Yes that’s what the Manuel says. We go by how our machines are driven. If it’s driven slow and on trails then we do it at 500 on first service. If we drive it hard then we do it at 200.
@krawlworkspowersports if I do my own valve lash will it void the manufacturer warranty?
No.
Why are you doing fill till ya spill on differentials when owners manual say like 400ml for rear and 250ml on front differential?
When you measure that much, it fills right to the top. So why measure? Just fill it till it runs out. I don’t mean pours out. When you see it crest the hole stop!
Wish they would've put a spin on filter on these machines.
I added the spin on filter. Mr.RPM or RNG sells them and I installed one. Makes the filter change so much easier.