Wheel loader hitachi engine Cummins QSB6.7 CM2350 Machine kranking but engine Not starting Ecu ,injectors, engine harness, feul rail line ,all change and diagnostic by inline 7 no trouble code
Would it have not been easier to connect the wiring harness to the suspect ECM without removing the known good ECM and see if coms and a start could have been initiated? or were the wires not long enough?
@donaldsterling9305 remove the ICP Sensor and use a pressure gauge in the sensor hole to check injection actuation oil pressure while cranking, it should be between 700 - 900 PSI while cranking!
Cummins QSB6.7 CM2350 kranking but engine not working i change all injectors and hi feul pump and rail pressure line with 3 sensor... and enngin ecu and diagnostic not have errorscode ..??
Pro tip you can back fill the air tanks to get rid of the noise a majority of the time
@usfarmcop Oh Yeah!! Thanks for sharing!
I enjoy these buses from the summer.
@ivanpeterzell695 They are pretty nice!
Wheel loader hitachi engine Cummins QSB6.7 CM2350
Machine kranking but engine Not starting
Ecu ,injectors, engine harness, feul rail line ,all change and diagnostic by inline 7 no trouble code
Would it have not been easier to connect the wiring harness to the suspect ECM without removing the known good ECM and see if coms and a start could have been initiated? or were the wires not long enough?
@JohnSmith-wb6kq The wires were not long enough!
Grasias
@martinarrieta248 My Pleasure!
I've got a question about a 7.3 I've narrowed it down to either the PCM or the HPOP how do I test the HPOP
@donaldsterling9305 remove the ICP Sensor and use a pressure gauge in the sensor hole to check injection actuation oil pressure while cranking, it should be between 700 - 900 PSI while cranking!
Bro I wish I can be your apprentice, and I need diagnostic scan tool for heavy truck please which one is good for heavy duty trucks and commercial car
@adamissah452 • if you work on heavy duty trucks a diesel laptop would be what I would recommend!
Cummins QSB6.7 CM2350 kranking but engine not working i change all injectors and hi feul pump and rail pressure line with 3 sensor... and enngin ecu and diagnostic not have errorscode ..??
@hussam-mq2fe Did you check compression?
@@KITS_Auto_and_Truck_Repair how to check compression
I test by inline 7 diagnostic tool no trouble code
Why the injectors signal not found in test 2 pin injector there is no postive no plamping by test light
Can you give me the power and ground at the computer please?
Never mind!! Thanks for your help
@MikeJakson-y5w You can get them from mitchell prodemand
@MikeJakson-y5w Ah ok!
Feedback - dont make a video with an ear piercing alarm noise.
@SoldfMC Sorry for that noise, the buzzer was hard to get to and we couldn't find the fuse for it! I hope it wasn't too bad!