Honda Valkyrie | Making Carburetor Dowel Pins 🏍
HTML-код
- Опубликовано: 20 окт 2024
- Hello Everyone! As promised to a viewer here is the video of me making new dowel pins fit into the carburetors. A couple pins were damaged when removing them 😐
A lathe would have made the project much easier! I also didn't have the correct size drill bit or any other tools than the ones I used.
I hope you enjoy!
Your content is amazing, so thankful for your videos
Thanks for the video, The problem with my Valkyrie is the "T" fitting that delivers the fuel to the carbs is leaking do you have any suggestions? Maybe a sealant?
Update: I was able to remove the Right aft carb without removing all six, replaced the "O" rings on the "T" fitting and it is not leaking.
I was just going to reply to your previous comment then I saw this one. I’m glad you were able to repair it! Make sure you check synchronization since you removed a carb from the assembly.