How to check and add transmission fluid on a 2003 Dodge Neon (2000 - 2005)
HTML-код
- Опубликовано: 22 авг 2024
- Here is how to check and add transmission fluid on a 2003 dodge Neon. This should also work with any second generation 2000 to 2005 Dodge Neon. Be sure not to overfill.
Thank you. I pulled this out instead of one to check oil. 74 yo female. Couldn't figure out where to put it back !! 😂 Glad to know i need transmission oil too!
Thank u for posting this at all and I know its better for content providers to have longer videos ad wise but a minute and a half checking the dipstick where its impossible to miss where to check it. Just needed to know how to add. 20 seconds on that.
This has exactly what I was looking for. Thank you!
Thank you for the video. I have a 98 Neon, The transmission started slipping a couple days ago and when I checked the fluid per your instructions it looks like it's bone dry. I don't even know the type of fluid because I got it used and there is no manual. I hope I can take care of this myself since a shop would charge an arm and a leg.
Thanks for the video man
thanks for the video
does your dipstick says add-warm- hot? if your engine is hot and your fluid reading in is "warm" level do i need to add fluid?. i used my car for 1 hour and when i checked the fluid the level was in "warm" level. do i need to add fluid with this reading?
Thank yu fr the info bcuz sum1 tryd to misguide my mother who is an elder nd it irritated me so had to double chek nd send her the video thank yu onc again
When I put it on drive it idling and it.dosent want go but when it go for little bit then it idle again why...help me
question! when the cars hot! and in park? then you check it? when i turn the car off the transmission fluid is full but when its running in park its low.
so my transmission has not been shifting ie, at stop lights, when I go to move again, i'll hit the gas and the engine revs and I'm in neutral and it takes like 5 seconds to shift into gear. So I took the level of the trans fluid both hot and cold. when it was cold, it looked like it was at a normal level. between both of the cold marks, but when I tested it after driving it a bit, the dipstick was bone dry. so do I need to add fluid?
I get the same thing and I just swapped my rad cause my trans cooler blew. It has me so frustrated it's unreal
Thank