Kohler Smart Choke Technology
HTML-код
- Опубликовано: 16 май 2021
- Owner had trouble starting Engine and i finally got it to run but him not being mechanically inclined he still had issues. Found out the thermostat was bad. In ohms it should be reading 15 ohms + or - 10 according to what i read. I got like 1. The oil pressure switch was pushing 14 volts to the thermostat to heat coil. Problem was while trying to start the choke wouldnt stay closed, it would bounce open and closed at the butterfly. I attached a small spring to to help hold the choke closed at cold start. If its cold the the wind vane willl open just enough but with engine cold itll want to shut down again. Then the choke is held closed by the spring again and engine will continue running, until the thermostat heats up to do its job. Then the engine will continue to run as it should. Alot of play in the thermostat and there should be any...
Развлечения
I'm having the same issue with my Smart "Joke" system .... finally figured out the issue thanks to you! Thanks you!!!
That sounds like a great idea when you say it fast, but there is a fundamental problem. The air filter housing goes on before the bracket, preventing access to the choke linkage with a spring or any other magical device. I am determined to delete the air vane and the bimetal choke coil. I am going to install the dual wire control assembly and choke linkage used on 7000 engines equipped with the conventional choke. The hole on the operators control panel for the choke cable is already there. Just cut the label to mount it.
Thinks man u got me running again with this video
Slightly losing the two screws on the thermostat flat head screwdriver turn to the left the housing of thermostat that tightens up the spring inside allowing butterfly to fully close give that a shot that is how to adjust the butterfly on the smart show engine
Don't forget to tighten the two screws back up on choke housing
Yes thanks so much.
I may be starting my xt1 wrong it makes no sense to me to have full throttle at start i miss the manual choke
Oh shit this video and the comments. I’m missing a linkage and my old thermostat can be rotated to make it stronger