Hey Travis, what’s keeping the step side from laying all the way ? Is it the front crossmember ? It may be the angle of the picture but it seems to seat higher than the your builds with the cupped control arms. 🔥🔥🔥🔥
I don't know how you can deal with an HoA...To me it would feel like prison. Sure you have a beautiful home and neighborhood buuuuuut to not have that much freedom on your own property would be terrible! Install looks clean bud
![Felix "Unfair" | [Stray Kids : SKZ-PLAYER]](http://i.ytimg.com/vi/Oswujxm2Ag0/mqdefault.jpg)
Love the step side at the end of the video
Same!
Great job can’t wait to start my 69C 10 just getting all my parts together
Let me know if I can help. Good luck!
I really like the new design. Looks sick.
I agree!
Definitely need one installed on mine
They are great
Just have the factory brace there now
Great job Travis 👍
Thank you!
As always, great work and very informative....
P.S. say hi to the wonderful HOA. What would the world do with out them 😂🤣
lol thanks!!
Gettin her done nice!
Thank you
Can you use that spray paint on your frame or is that recommended?
Hey Travis, what’s keeping the step side from laying all the way ? Is it the front crossmember ? It may be the angle of the picture but it seems to seat higher than the your builds with the cupped control arms. 🔥🔥🔥🔥
@@frente2zapatista it had factory inner fenders and a mini notch on 20s. It was bagged differently than my other trucks.
Got it, thanks for the reply 👊
Get you a “long barrel” air chisel from Harbor freight. It will make quick work of those rivets.
Thanks for the feedback. Definitely need some attachments for the air hammer. I need a bigger compressor too. This one doesn’t cut it.
I’m wondering if I need one of these for my 60?
No you have a different crossmember
Can I use this crossmember if I’m running a two piece drive shaft?
Yes
Thank you brother. Can’t wait to see when you install the sniper efi sistem
Where did u buy that face shield at??
I got it from Amazon.
@@SIMPLE.C10 I know I've looked on there before, I try again
🎉🎉🎉🎉🎉nice work
Thanks
Can this be mounted on a 60-62?
No. They have a different style crossmember because it’s an x frame.
I assume you went with a one piece driveshaft ? If so where did you get your driveshaft from ?
@@devansmith5874 I just use the factory driveshaft in all my builds. Usually needs trimmed down an inch.
@ do you have any videos explaining the process Of using the factory driveshaft?
@ what do you bolt the carrier bearing to?
@ there’s two holes in the middle of the bracket to offer the billet cpp style.
@@SIMPLE.C10 awesome thanks for the help
I don't know how you can deal with an HoA...To me it would feel like prison. Sure you have a beautiful home and neighborhood buuuuuut to not have that much freedom on your own property would be terrible! Install looks clean bud
@@DadbrosGarage they actually aren’t that bad. Thanks so much.
H.A.O fines lmao
Lol