Plastic Behavior in the Sheet Extrusion Line

This short video is a clip from Paulson Training's interactive video program titled "Sheet Extrusion Technology". This is from Lesson #4 -- Plastic Behavior in the Sheet Extrusion Line. Information on the complete sheet extrusion training program can be found at:
www.paulsontrai...
Sheet Extrusion Technology is designed to be used in conjunction with Paulson's 9 lesson interactive video program titled Single Screw Extrusion course. It provides an overview of the operation of a typical sheet extrusion line. The various lessons in the program cover topics ranging from parts and operation, to controlling plastic flow in the die, to troubleshooting the sheet extrusion line.
This training program has valuable information for every employee involved with sheet extrusion. The 7 lessons in the complete program are:
Lesson 1 -- The Sheet Extrusion Line: Parts and Operation
Lesson 2 -- Sheet Extrusion Dies
Lesson 3 -- Controlling Plastic Flow in the Die
Lesson 4 -- Plastic Behavior in the Sheet Extrusion Line
Lesson 5 -- Pre-Start, Start-up, and Steady-State Operating Procedures
Lesson 6 -- Safety and Shutdown Procedures
Lesson 7 -- Troubleshooting the Sheet Extrusion Line

[@spencerstromberg]

So is it good to draw it down? I’m building a small scale extruder to make 1/4” sheets. Should i extrude .28” and have the rollers smash it down to .26” and assume the material will cool to .25?

[@shaikabdulmathin9479]

Hi

[@saipranav979]

h

[@RohitKumar-nr1gg]

Hindi