Winwing Orion 2 F/A-18 Hornet Throttle + Finger Lift Kit Assembly and Unit Test Video
HTML-код
- Опубликовано: 18 окт 2024
- #winwing, #F-18, #howto, #hornet
This is not sponsored video, I've purchased the kit to create VR platform accompanying the new Pimax Crystal.
Assembling the Orion2 F/A-18 Throttle + Finger lift kit. Followed by testing the unit function via the Provided Software. The software itself is very good, very intuitive with diagram showing the unit and the buttons or value being manipulated from the unit.
The unit is consited of combination of metal and plastic but feel very sturdy and durable. Similar with Early Thurstmaster A-10 Warthog Hotas Kit.
Although the later have more metal built into the units. Nonetheless its a well built Throttle, simulating the F/A-18 throttle and it's unique finger lift system for Engine to idle and afterburner.
winwingsim.com...
Great Video Matey, I wish that I had seen it before I ordered my HOTAS as I did not ordered the finger lift kit at the same time. The video also would have saved me hours in the initial HOTAS setup. Great work!! All the best Paul
video starts at @5:21 thanks for the help!
Thanks for the video, greatly appreciated!
thanks for the detailed video. is this throttle ueasble with the right hand?
If you put in the right zside I think will be awkward its meant for left hand just like in the real jet fighter unfortunately they are not ambidextrous
Can you adjust the off gate a little higher so you can implement it for reverse thrust?
Thank you for the video, helped me a lot!
Great vid, thankyou!
I have 1 question, about the after burner detent, mil power is at 70% and it seems if u go to ab it just go to 100% fully, like no steps on the detent
Sending it on the F15EX throttle and the F16 stick with the extra buttons
does it have vibrator like F15 throttle grip?
@@thud28783 no it desnt have