I just added 37s to my new 24 F350 i didnt even have to remove the plastic as you had to still plenty of room although mine has plow prep kit so 2.5 inches more of coils thanks brother!
Beautiful truck! Nice wheel setup! I’m about to get a 24 F-250 Lariat Tremor and I want to go with 22’s on Ridge Grappler 37x12.5x22. I want this same amount of poke. I’m still torn between a 22” or 20” rim. Thanks for the video.
@@americandream_89 thanks I sure hope it is. From all the research I’ve seen, all I’ll need is a 2.5” level kit and make sure we purchase the right offset on the rim. So that’s all I plan on doing.
@@4LEAFCLOVER1980I have 35” Mud Gapplers on an F150 w/ 6” Lift. . . Gonna be hard sitting 37’s with a Leveling Kit! But I think you said F250. . . Don’t know how this Jack Wagon (RUclips Guy) got F150 from you saying F250. . . You can tell he’s not the Brightest WhyteBoy in The Barn! Well technically he is, just not Mentally Bright! He’s Complexion Bright! 😅
Hopefully you have some PPF on the side of that truck because these will blast the side of your truck. CJC off-road has a video on how to trim these trucks to fit 37s 38s and even 40s the tremor is also lifted from the factory. On these new fords you would be better off with a +12 to +18 and a level you can get full articulation lock to lock.
I have the same truck and looking at putting 37x18s on it. Would you say it rides softer than the 35s? Not a big fan of how the truck jerks up and down driving on certain roads. Don’t really want to put a Carli suspension if I don’t have too. Thanks for all the F250 videos, very informative. Keep it up brother.
Putting 37s on 18 inch rims like the tremors comes with will help your ride for sure. You will lose some tow capacity. As the factory tires have a load rating per tire of 4080lbs most 37s are 37-3900. But your ride will be much better. Appreciate the feedback buddy.
Great I have the exact same truck as you and put fuel 20x9 +1 37's on and have the same minor rubbing that you do. Question though, have you noticed a difference in your adaptive cruise that it's almost jerky throttle when trailing coming up on someone to match their speed?
@@dwuchterl yes. It did it really bad before calibration of my speed and ecu reset. I didn’t notice it after that but could have gotten used to it lol I’ll check again soon. Do you have everything recalibrated?
@@gaetanconnelly6540 thanks buddy. The tremor does have a factor lift over the regular trucks. I just meant that I didn’t modify the tremor at all. It’s the only version truck you can put 37s on without rub. Congrats on the truck you will love it.
What is the specific offset on the wheels on your truck? The caption says 0 offset, but you say they are negative offset during the video. Are they negative and if so, negative what? Thanks for your help!
@@americandream_89 Thanks for your prompt response. I really appreciate the information. I have a stock 2024 F350 Tremor. I have already purchased 20x9 wheels with -12 offset. I am hoping to purchase new 35/12.50R20 Falken AT4W tires, and I am trying hard to determine if they will rub at all before I buy them. I don’t want any rub, and I don’t want to add any lift.
@@toddw392 from everything I’ve seen you should be good. The factory tire is almost a 35. The -12 will stick out further then what I’ve got on. But the 35 should let you clear. Have you watched CJC video’s? They might have clarification on a -12
@americandream_89 you're welcome my good Sir I have a question you may or may not know but imma ask anyway lol I just took possession of a 24 F350 XL with the STX pkg 7.3 Godzilla it came with the snow plow prep pkg and I've heard 37s will fit up front on stock wheels with zero rub? Do you if that is factual? Thank you kindly ☺️
Correct As stated in the video mud flaps will not work but I’ve still got the factory plastic corner covers on. If you check my shorts I loaded 1500lbs in the bed and checked it again.
Wheels and tires looking good also that grass is on point brother
Thanks
If all works out, I’ll have Dixie chopper and bad boy out to compete cutting it.
I just added 37s to my new 24 F350 i didnt even have to remove the plastic as you had to still plenty of room although mine has plow prep kit so 2.5 inches more of coils thanks brother!
@@toddreeder3082 I didn’t realize the plow prep added 2.5” of lift that’s wild. Thanks for the info.
They look good!
Beautiful truck! Nice wheel setup! I’m about to get a 24 F-250 Lariat Tremor and I want to go with 22’s on Ridge Grappler 37x12.5x22. I want this same amount of poke. I’m still torn between a 22” or 20” rim. Thanks for the video.
Thanks
Sounds like a good looking setup.
How much lift do you need to put 37s on a f-150?
@@americandream_89 thanks I sure hope it is. From all the research I’ve seen, all I’ll need is a 2.5” level kit and make sure we purchase the right offset on the rim. So that’s all I plan on doing.
@@4LEAFCLOVER1980you’re not getting 37’s on a F150 with a level…. An F250 yes
@@DJGonzoNYC that was a typo! I meant to say F-250. I was in a F-150 Tremor but I just sold it last Friday. Moving on up to a Super Duty now 🤙🏾
@@4LEAFCLOVER1980I have 35” Mud Gapplers on an F150 w/ 6” Lift. . . Gonna be hard sitting 37’s with a Leveling Kit! But I think you said F250. . . Don’t know how this Jack Wagon (RUclips Guy) got F150 from you saying F250. . . You can tell he’s not the Brightest WhyteBoy in The Barn! Well technically he is, just not Mentally Bright! He’s Complexion Bright! 😅
Brother just the 37s on tons of room on mine man! No issues at all now i want 38s lol😅
@@toddreeder3082 I’ve seen them with 38s they look slick.
I need to see a ditch test with this setup.
It would fail a”Ditch” test 5:00😢
Hopefully you have some PPF on the side of that truck because these will blast the side of your truck. CJC off-road has a video on how to trim these trucks to fit 37s 38s and even 40s the tremor is also lifted from the factory. On these new fords you would be better off with a +12 to +18 and a level you can get full articulation lock to lock.
@@Sdukes001 I’ve got full articulation without any rub.
@ what I mean is full articulation not parked in the driveway. You have no run lock to lock.
@ I drive my truck every where….. articulates fine everywhere
@ looks like a pavement princess
I have the same truck and looking at putting 37x18s on it. Would you say it rides softer than the 35s? Not a big fan of how the truck jerks up and down driving on certain roads. Don’t really want to put a Carli suspension if I don’t have too. Thanks for all the F250 videos, very informative. Keep it up brother.
Putting 37s on 18 inch rims like the tremors comes with will help your ride for sure. You will lose some tow capacity. As the factory tires have a load rating per tire of 4080lbs most 37s are 37-3900. But your ride will be much better.
Appreciate the feedback buddy.
Still liking the Boulder MT’s?
Looking at getting a set for the stock 20” (non tremor) wheel in a 295/65/20.
@@mikeoneil350 I like them. For an aggressive pattern they ride and drive like a stock tire.
Great I have the exact same truck as you and put fuel 20x9 +1 37's on and have the same minor rubbing that you do. Question though, have you noticed a difference in your adaptive cruise that it's almost jerky throttle when trailing coming up on someone to match their speed?
@@dwuchterl yes. It did it really bad before calibration of my speed and ecu reset. I didn’t notice it after that but could have gotten used to it lol I’ll check again soon. Do you have everything recalibrated?
wow.... proper truck
Looks awesome my friend! I thought the tremor had a slight factory lift on it? Picking up my 2024 9n Wednesday, excited!
@@gaetanconnelly6540 thanks buddy. The tremor does have a factor lift over the regular trucks. I just meant that I didn’t modify the tremor at all. It’s the only version truck you can put 37s on without rub. Congrats on the truck you will love it.
What is the specific offset on the wheels on your truck? The caption says 0 offset, but you say they are negative offset during the video. Are they negative and if so, negative what? Thanks for your help!
@@toddw392 they are 0 offset sorry for the confusion. 20x9 with 0 offset
It will rub with a 20x10 and 37s
@@americandream_89 Thanks for your prompt response. I really appreciate the information. I have a stock 2024 F350 Tremor. I have already purchased 20x9 wheels with -12 offset. I am hoping to purchase new 35/12.50R20 Falken AT4W tires, and I am trying hard to determine if they will rub at all before I buy them. I don’t want any rub, and I don’t want to add any lift.
@@toddw392 from everything I’ve seen you should be good. The factory tire is almost a 35. The -12 will stick out further then what I’ve got on. But the 35 should let you clear. Have you watched CJC video’s? They might have clarification on a -12
@@americandream_89 Thanks again! I’ll check out CJC 👍
Who did you get the Lunatic rims from?
Socal custom wheels
Approximately how much taller does that beautiful truck sit over the stock tire and wheel?
@@toddreeder3082 I’m 1” from being 7’ tall if the car wash pole is correct
Gotcha brother what a gorgeous setup!
@@toddreeder3082 thanks buddy! I absolutely love this truck. Rides and drives great for a HD
@americandream_89 you're welcome my good Sir I have a question you may or may not know but imma ask anyway lol I just took possession of a 24 F350 XL with the STX pkg 7.3 Godzilla it came with the snow plow prep pkg and I've heard 37s will fit up front on stock wheels with zero rub? Do you if that is factual? Thank you kindly ☺️
With the 0 offset wheel, it still doesn’t rub the radius arm or swaybar?
I was thinking of doing the 37x12.50 with 17x8.5 wheels
Correct
As stated in the video mud flaps will not work but I’ve still got the factory plastic corner covers on. If you check my shorts I loaded 1500lbs in the bed and checked it again.
Did you say USAA member?
@@rorycompton8138 yes
This is with no lift correct?
Correct
@@americandream_89 Looks great, Thank you for the video and info.
@@teslabogger thanks buddy! No problem
@@americandream_89would the 37s have fit on the stock tires?
@@abc-ed1nr not without rubbing
Can a 37" fit in the spare location?
Everyone online says no. I haven’t tried yet. But I know Carli makes a trophy hitch kit that one will fit with it.
Thanks for the info, I will have to check out the Carli option
This is what happens when you do things HALF ASS…🤦🏽🤦🏿🤦🏼
Okay 😂