NXCAM Training | Lesson 3 - Our FIRST TOOL PATHS

NXCAM Training | Lesson 3 - Our FIRST TOOL PATHS ... In this lesson we are going to create our first tool paths and rough out this part complete ready for finishing, we are going to take a deep dive into the different roughing operations and go through the dialog boxes for the operation types.

[@tuoppi861]

Thank you for the great videos! Veryfying and anlayzing toolpaths stock levels, I would like to use more this mouse "click" options than compare only colors. When you make mouse click around the part, you can see actual stock in millimeters for the clicked point. Hopefully you show this option as well later videos :)

[@MachineX_]

@@tuoppi861 Hi mate!
This sounds like a great idea, I will try to showcase this in the next video! Thanks again for your support.

[@biswarupdas8480]

Hi I have one doubt like when we are using adaptive milling toolpath is it necessary to use line output because some machine cannot calculate too many G2 G3 Lines or we can use it with arc perp/ par with tool axis or is it a myth to use line output whenever we are using high speed toolpath strategies

[@MachineX_]

In my career I have always used “Arc - Perp/par to Tool Axis, but I have been lucky enough to be around top quality machines.
I believe adaptive milling strategies would be completely fine on most modern machines but I can imagine if you are using older machines then a more traditional cavity will may be more efficient as you could experience some machine “juddering”.
I hope this answers your question and thank you for the continued support!